| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during throttle with throttle position sensor body assembly removal/installation are shown below.
1.DRAIN ENGINE COOLANT
25760 2.DISCONNECT VACUUM TRANSMITTING HOSE ASSEMBLY
12262 3.DISCONNECT NO. 2 VENTILATION HOSE
17735 4.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
16282 5.DISCONNECT NO. 5 WATER BY-PASS HOSE
16281 6.DISCONNECT NO. 4 WATER BY-PASS HOSE
22030 7.REMOVE THROTTLE WITH THROTTLE POSITION SENSOR BODY ASSEMBLY
22271 8.REMOVE THROTTLE BODY GASKET