Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM38G0E _51 Engine / Hybrid System _100527 1GR-FE ENGINE CONTROL _0467385 CRANKSHAFT POSITION SENSOR A

1GR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A516026N01
6.104,2.104 5.635,2.104 true 2.833,2.729 2.833,3.01 2.833,3.01 2.344,3.01 true 2.396,2.604 1.927,2.604 false 6.188,1.99 6.469,2.344 0.281,0.354 18 false 1 2.104,2.896 2.385,3.25 0.281,0.354 18 false 2 1.844,2.5 2.167,2.708 0.323,0.208 10 false ●

Procedure Part Name Code
Z101186

Z101188

Z101187

1 COMPRESSOR WITH MAGNET CLUTCH - - - -
2 CRANKSHAFT POSITION SENSOR 11401G (Click here) - -

● Non-reusable part - -

PROCEDURE

Hide 1.REMOVE COMPRESSOR WITH MAGNET CLUTCH

Hide 11401G 2.REMOVE CRANKSHAFT POSITION SENSOR

a.
A516027N01
0.479,0.063 0.896,0.365 0.417,0.302 18 true i, ii 4.24,0.104 4.656,0.438 0.417,0.333 18 false iii

i.

Disconnect the crankshaft position sensor connector.


ii.

Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.



iii.

Perform this procedure only when reusing the crankshaft position sensor.

1. Remove the O-ring from the crankshaft position sensor.

NOTICE:
·

Make sure to only remove the O-ring with bare hands.

·

When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.

·

If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.