Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Start Function) › 2021.04–2021.07
RM38G0E _58 Vehicle Interior _100610 THEFT DETERRENT / KEYLESS ENTRY _0467507 ENTRY AND START SYSTEM(for Start Function) C

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Start Function)  B277B96  Fingerprint for Engine/Power Switch Component Internal Failure  


DESCRIPTION

This DTC is output when the certification ECU (smart key ECU assembly) continuously receives engine switch malfunction signals over a certain period of time.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
B277B96 Fingerprint for Engine/Power Switch Component Internal Failure Engine switch malfunction signal input continues for 10 seconds Engine switch Entry&Start A DTC output confirmation operation:

Any of the conditions below is met


·

Fingerprint authentication is active and an engine start operation is performed

·

Fingerprint information is added or cleared



CAUTION / NOTICE / HINT

NOTICE:
·

When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

·

The entry and start system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the entry and start system (for Start Function) after confirming that the communication systems are functioning properly.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Start Function)>HOW TO PROCEED WITH TROUBLESHOOTING

·

Before replacing the engine switch, refer to Service Bulletin.

·

After performing repairs, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".



PROCEDURE

1.REPLACE ENGINE SWITCH
a.

Replace the engine switch with a new one.

HINT:

for 1GR-FE:

Click hereEngine / Hybrid System>1GR-FE (STARTING)>ENGINE SWITCH>REMOVAL

for V35A-FTS:

Click hereEngine / Hybrid System>V35A-FTS (STARTING)>ENGINE SWITCH>REMOVAL


Result:
Proceed to
NEXT




NEXT

2.REGISTER COMMUNICATION ID (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - ENGINE SWITCH)
2.REGISTER COMMUNICATION ID (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - ENGINE SWITCH)
a.

Register the ECU code registration.

HINT:

Refer to Service Bulletin.


Result:
Proceed to
NEXT




NEXT

END (ENGINE SWITCH WAS DEFECTIVE)