Use these procedures to troubleshoot the power integration system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, check the CXPI communication function to ensure that there are no malfunctions in the communication system.
| Proceed to |
|---|
| No DTCs output |
| DTCs output |
No DTCs output
DTCs output
Click herePower Source / Network>NETWORKING>CXPI COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check for DTCs and make a note of any codes that are output.
Clear the DTCs.
Semiconductor power integration ECU
power distribution box assembly
Recheck for DTCs.
Semiconductor power integration ECU
power distribution box assembly
| Proceed to |
|---|
| No DTCs output |
| DTCs output |
No DTCs output
DTCs output
Click herePower Source / Network>POWER DISTRIBUTION>POWER INTEGRATION SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Refer to the Problem Symptoms Table.
Click herePower Source / Network>POWER DISTRIBUTION>POWER INTEGRATION SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| Fault is not listed in problem symptoms table |
| Fault is listed in problem symptoms table |
Fault is not listed in problem symptoms table
Fault is listed in problem symptoms table
Data List / Active Test
Click herePower Source / Network>POWER DISTRIBUTION>POWER INTEGRATION SYSTEM>DATA LIST / ACTIVE TEST
Terminals of ECU
Click herePower Source / Network>POWER DISTRIBUTION>POWER INTEGRATION SYSTEM>TERMINALS OF ECU
Problem symptoms table
Click herePower Source / Network>POWER DISTRIBUTION>POWER INTEGRATION SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT