These DTCs are stored when a malfunction occurs in the No. 1 active noise control microphone system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B1AA296 | Front Left Microphone Circuit Component Internal Failure | Engine running, engine speed is 1200 rpm or higher 3 seconds after the ignition switch is turned to ACC, the stereo component equalizer assembly detects a malfunction in the No. 1 active noise control microphone for 4 seconds or more continuously* |
·
Harness or connector
·
No. 1 active noise control microphone
·
Stereo component equalizer assembly |
Active Noise Control | A |
| B1AA31C | Front Left Microphone Circuit Circuit Voltage Out of Range | When the stereo component equalizer assembly detects a No. 1 active noise control microphone connection malfunction for 4 seconds or more continuously 3 seconds after the ignition switch is turned to ACC* |
·
Harness or connector
·
No. 1 active noise control microphone
·
Stereo component equalizer assembly |
Active Noise Control | A |
*: Malfunction monitoring is not performed during the following conditions to prevent erroneous detection.
The battery voltage is less than 9.5 V.
Before 3 seconds have elapsed after the battery voltage has returned to normal.
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Disconnect the S24 stereo component equalizer assembly connector.
Disconnect the d24 No. 1 active noise control microphone connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(S24,d24)Location & Routingewd_type=routing;type=c,c;code=S24,d24 Click Connector(S24)Body>No. 2 Floor Wire / Step Rear Floor Wire LH>Stereo Component Equalizer Assemblyewd_type=component;type=c;code=S24;pinno=1,5 Click Connector(d24)Body>No. 1 Roof Wire>Active Noise Control Microphone (Front LH)ewd_type=component;type=c;code=d24;pinno=1,2 |
||
| S24-1 (MC1+) - d24-1 (MC1+) | Always | Below 1 Ω |
| S24-5 (MC1-) - d24-2 (MC1-) | Always | Below 1 Ω |
| S24-1 (MC1+) - Body ground | Always | 10 kΩ or higher |
| S24-5 (MC1-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Replace the No. 1 active noise control microphone with a new or known good one.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B