These DTCs are stored when a malfunction occurs in the No. 4 active noise control microphone system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B1AAA96 | Rear Center Microphone Circuit Component Internal Failure | Engine running, engine speed is 600 rpm or higher 3 seconds after the ignition switch is turned to ACC, the stereo component equalizer assembly detects a malfunction in the No. 4 active noise control microphone for 4 seconds or more continuously* |
·
Harness or connector
·
No. 4 active noise control microphone
·
Stereo component equalizer assembly |
Active Noise Control | A |
| B1AAB1C | Rear Center Microphone Circuit Circuit Voltage Out of Range | When the stereo component equalizer assembly detects a No. 4 active noise control microphone connection malfunction for 4 seconds or more continuously 3 seconds after the ignition switch is turned to ACC* |
·
Harness or connector
·
No. 4 active noise control microphone
·
Stereo component equalizer assembly |
Active Noise Control | A |
*: Malfunction monitoring is not performed during the following conditions to prevent erroneous detection.
The battery voltage is less than 9.5 V.
Before 3 seconds have elapsed after the battery voltage has returned to normal.
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Disconnect the S24 stereo component equalizer assembly connector.
Disconnect the d27 No. 4 active noise control microphone connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(S24,d27)Location & Routingewd_type=routing;type=c,c;code=S24,d27 Click Connector(S24)Body>No. 2 Floor Wire / Step Rear Floor Wire LH>Stereo Component Equalizer Assemblyewd_type=component;type=c;code=S24;pinno=4,8 Click Connector(d27)Body>No. 1 Roof Wire>Active Noise Control Microphone (Rear2 Center)ewd_type=component;type=c;code=d27;pinno=1,2 |
||
| S24-4 (MC4+) - d27-1 (MC4+) | Always | Below 1 Ω |
| S24-8 (MC4-) - d27-2 (MC4-) | Always | Below 1 Ω |
| S24-4 (MC4+) - Body ground | Always | 10 kΩ or higher |
| S24-8 (MC4-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Replace the No. 4 active noise control microphone with a new or known good one.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B