| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | RADIATOR ASSEMBLY | 16400 | - | - | - |
| 2 | DRAIN ENGINE OIL | - | - | ( ) |
- |
| 3 | CRANKSHAFT PULLEY | 13471 | ( ) |
- | - |
| 4 | TIMING CHAIN CASE OIL SEAL | 11301C | ( ) |
- | - |
| ● | Non-reusable part | - | - |
16400 1.REMOVE RADIATOR ASSEMBLY
2.DRAIN ENGINE OIL
13471 3.REMOVE CRANKSHAFT PULLEY
| *a | Hold | - | - |
|
Turn | - | - |
Using SST to hold the crankshaft pulley, loosen the crankshaft pulley set bolt. Further loosen the crankshaft pulley set bolt until 2 or 3 threads remain screwed into the crankshaft.
Using SST and the crankshaft pulley set bolt, remove the crankshaft pulley.
Apply lubricant to the threads and end of SST.
11301C 4.REMOVE TIMING CHAIN CASE OIL SEAL
| *a | Protective Tape | - | - |
Using a screwdriver with its tip taped, pry out the timing chain case oil seal.
After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.