| *1 | FLUID COUPLING ASSEMBLY WITH FAN | *2 | FAN PULLEY |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 25 | NO. 2 INTERCOOLER COOLING RADIATOR ASSEMBLY | 16550B | - | - | - |
| 26 | NO. 1 RADIATOR TO SUPPORT SEAL | 16561C | - | - | - |
| 27 | CONNECTOR COVER | 82H21F | - | - | - |
| 28 | ELECTRIC WATER PUMP ASSEMBLY | 161B0 | - | - | - |
| 29 | NO. 1 WATER BY-PASS PIPE | 16268 | - | - | - |
| 30 | WATER HOSE JOINT | 16035 | - | - | - |
| 31 | FRONT WATER BY-PASS JOINT SUB-ASSEMBLY | 16035B | - | - | - |
| 32 | NO. 1 RADIATOR BRACKET | 16582 | - | - | - |
| 33 | NO. 9 WATER BY-PASS HOSE | 16297 | - | - | - |
| 34 | NO. 8 WATER BY-PASS HOSE | 16296 | - | - | - |
| 35 | DISCONNECT FRONT RADIATOR SIDE AIR GUIDE PLATE LH | 16695A | - | - | - |
| 36 | NO. 2 RADIATOR BRACKET | 16583 | - | - | - |
| 37 | REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH | 16695A | - | - | - |
| 38 | FRONT RADIATOR SIDE AIR GUIDE PLATE RH | 16691A | - | - | - |
| *A | w/o Condenser Fan | *B | w/ Condenser Fan |
| *1 | ENGINE ROOM MAIN WIRE | - | - |
| ● | Non-reusable part | - | - |
| *A | w/ Condenser Fan | - | - |
| *1 | RADIATOR ASSEMBLY | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the radiator assembly removal/installation are shown below.
1.REMOVE FRONT BUMPER ASSEMBLY
for Standard
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Standard)>REMOVAL
for Aero Type
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Aero Type)>REMOVAL
51410 2.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
3.DRAIN ENGINE COOLANT
4.DRAIN COOLANT (for Intercooler)
5.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
11209 6.REMOVE V-BANK COVER SUB-ASSEMBLY
17700L 7.REMOVE AIR CLEANER ASSEMBLY RH WITH AIR CLEANER HOSE ASSEMBLY RH
17800 8.REMOVE AIR CLEANER ASSEMBLY LH WITH AIR CLEANER HOSE ASSEMBLY LH
16261 9.DISCONNECT WATER BY-PASS HOSE
16260 10.DISCONNECT WATER BY-PASS HOSE ASSEMBLY
|
Move the Retainer Upwards |
|
Disconnect the Water By-pass Hose Assembly |
16264D 11.DISCONNECT NO. 2 WATER BY-PASS HOSE
164A2 12.REMOVE RADIATOR RESERVE TANK ASSEMBLY
44369A 13.REMOVE NO. 1 OIL RESERVOIR BRACKET
16571C 14.REMOVE NO. 1 RADIATOR HOSE
16572D 15.DISCONNECT NO. 2 RADIATOR HOSE
| *a | Push | - | - |
16278 16.DISCONNECT NO. 2 WATER BY-PASS PIPE
17.DISCONNECT OIL COOLER ASSEMBLY WITH OIL COOLER HOSE
18.DISCONNECT OIL COOLER TUBE SUB-ASSEMBLY
16364A 19.REMOVE COOLING FAN WIRE
Push the lever down to release the lock and disconnect the connector A.
Disconnect the connector B.
Remove the 2 bolts and cooling fan wire.
82121 21.DISCONNECT ENGINE WIRE
17368G 22.REMOVE NO. 1 AIR TUBE SUPPORT
16711 24.REMOVE FAN SHROUD
Detach the 2 clamps.
Loosen the 4 nuts holding the fluid coupling assembly with fan.
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts.
Remove the fan shroud together with the fluid coupling assembly with fan.
Be careful not to damage the radiator core.
Remove the fan pulley from the engine water pump assembly.
16550B 25.REMOVE NO. 2 INTERCOOLER COOLING RADIATOR ASSEMBLY
16561C 26.REMOVE NO. 1 RADIATOR TO SUPPORT SEAL
82H21F 27.REMOVE CONNECTOR COVER
161B0 28.DISCONNECT ELECTRIC WATER PUMP ASSEMBLY
16268 29.DISCONNECT NO. 1 WATER BY-PASS PIPE
16035 30.DISCONNECT WATER HOSE JOINT
16035B 31.DISCONNECT FRONT WATER BY-PASS JOINT SUB-ASSEMBLY
16582 32.REMOVE NO. 1 RADIATOR BRACKET
16297 33.DISCONNECT NO. 9 WATER BY-PASS HOSE
16296 34.DISCONNECT NO. 8 WATER BY-PASS HOSE
16695A 35.DISCONNECT FRONT RADIATOR SIDE AIR GUIDE PLATE LH
16583 36.REMOVE NO. 2 RADIATOR BRACKET
16695A 37.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH
16691A 38.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH
44402 39.DISCONNECT NO. 1 POWER STEERING OIL COOLER SUB-ASSEMBLY
88710E 40.DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
Remove the bolt and disconnect the air conditioning tube and accessory assembly.
Remove the O-ring from the air conditioning tube and accessory assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88711 41.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
42.REMOVE RADIATOR WITH COOLER CONDENSER ASSEMBLY
w/ Condenser Fan:
|
Remove in this Direction | - | - |
Detach the clamp and disconnect the connector.
Remove the 6 bolts.
Remove the radiator from the vehicle with cooler condenser assembly as shown in the illustration.
Perform the following procedure with 2 or more people to prevent damage to the radiator with cooler condenser assembly.
When removing the radiator with cooler condenser assembly from the vehicle, do not apply excessive force to the cooler pipe or cooling hoses.
w/o Condenser Fan:
|
Remove in this Direction | - | - |
Remove the 6 bolts.
Remove the radiator from the vehicle with cooler condenser assembly as shown in the illustration.
Perform the following procedure with 2 or more people to prevent damage to the radiator with cooler condenser assembly.
When removing the radiator with cooler condenser assembly from the vehicle, do not apply excessive force to the cooler pipe or cooling hoses.
16572D 43.REMOVE NO. 2 RADIATOR HOSE
88590 44.REMOVE BLOWER ASSEMBLY WITH SHROUD (w/ Condenser Fan)
46.REMOVE COOLER BRACKET
16681 48.REMOVE UPPER RADIATOR AIR GUIDE PLATE
16561 49.REMOVE NO. 1 RADIATOR TO SUPPORT SEAL