Home › Engine / Hybrid System › V35A-FTS (LUBRICATION) › OIL PRESSURE SWITCH
RM38G0E _51 Engine / Hybrid System _100653 V35A-FTS LUBRICATION _0467580 OIL PRESSURE SWITCH A

V35A-FTS LUBRICATION  OIL PRESSURE SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
A488218N03
5.344,4.688 6.083,4.896 0.74,0.208 6.396,0.24 6.76,0.24 false 5.115,4.792 5.333,4.792 false 1.99,4.583 1.99,4.896 false 6.698,4.635 6.979,4.99 0.281,0.354 18 false 1 1.927,4.896 2.208,5.25 0.281,0.354 18 false 2 5.938,0.094 6.667,0.385 0.729,0.292 18 false 3, 4 5.396,4.719 6.156,4.875 0.76,0.156 8 false 15 (153, 11) 6.49,4.698 6.74,4.896 0.25,0.198 10 false ★

Procedure Part Name Code
Z101186

Z101188

Z101187

1 OIL PRESSURE SENDER GAUGE ASSEMBLY 83520 (Click here) - -
2 CONVERTER WITH CATALYST ASSEMBLY RH 17400M - - -
3 INSPECT ENGINE OIL LEVEL - (Click here) - -
4 INSPECT FOR OIL LEAK - (Click here) - -

V100146

N*m (kgf*cm, ft.*lbf): Specified torque
V100135

Adhesive 1344
★ Precoated part - -

PROCEDURE

Hide 83520 1.INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

a.
A487296C03
2.083,1.146 2.604,1.146 true 2.667,1.052 2.979,1.25 0.313,0.198 10 false *a 0.5,0.063 0.781,0.417 0.281,0.354 18 false i 3.813,0.052 4.094,0.406 0.281,0.354 18 false ii 1.969,2.083 2.25,2.438 0.281,0.354 18 false iii
*a Oil Inlet Port - -


i.

Apply adhesive to the area shown in the illustration.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:
·

Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.

·

Apply adhesive to the entire circumference of the thread.




ii.

Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine within 1 hour of installation.



iii.

Connect the oil pressure sender gauge assembly connector.



Hide 17400M 2.INSTALL CONVERTER WITH CATALYST ASSEMBLY RH