| *1 | OIL PAN DRAIN PLUG | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 6 | NO. 2 ENGINE UNDER COVER ASSEMBLY | 51420 | - | - | - |
| 7 | NO. 1 ENGINE UNDER COVER ASSEMBLY | 51410 | - | - | - |
| *A | w/ Cover | *B | w/o Cover |
| *1 | ENGINE SIDE COVER SUB-ASSEMBLY LH | *2 | ENGINE SIDE COVER SUB-ASSEMBLY RH |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
89491 1.INSTALL ENGINE OIL LEVEL SENSOR
Using an 8 mm socket wrench, install the engine oil level sensor with the 2 bolts.
Remove any dirt or foreign matter from the engine oil level sensor connector installation hole.
Apply a light coat of engine oil to the O-ring of the engine oil level sensor.
Install a new clip to the engine oil level sensor.
Connect the engine oil level sensor connector.
3.ADD ENGINE OIL
4.INSPECT ENGINE OIL LEVEL
5.INSPECT FOR OIL LEAK
51420 6.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
51410 7.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
|
Bolt A |
|
Bolt B |
|
Install in this Direction | - | - |
After attaching the 2 temporary holding guides of the No. 1 engine under cover assembly to the vehicle frame, set the No. 1 engine under cover assembly to the vehicle side while pulling the engine side cover sub-assembly RH and engine side cover sub-assembly LH as shown in the illustration.
Move the side of the No. 1 engine under cover assembly facing the front of the vehicle and attach the 2 temporary holding guides to the vehicle frame.
Install the 5 bolts (A) and 4 bolts (B).