| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( ) |
- | - |
| 2 | ROOF HEADLINING ASSEMBLY | - | - | - | - |
| 3 | REAR NO. 4 ROOF AIR DUCT | 88566U | - | - | - |
| 4 | REAR NO. 3 ROOF AIR DUCT | 88566T | - | - | - |
| *A | w/ Air Duct | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 5 | ROOF ANTENNA ASSEMBLY WITH COVER | - | - | - | - |
| 6 | ROOF ANTENNA ASSEMBLY | 86300J | - | - | - |
| *1 | ANTENNA COVER | *2 | ROOF ANTENNA HOUSING |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the roof antenna assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
2.REMOVE ROOF HEADLINING ASSEMBLY
88566U 3.REMOVE REAR NO. 4 ROOF AIR DUCT (w/ Air Duct)
88566T 4.REMOVE REAR NO. 3 ROOF AIR DUCT (w/ Air Duct)
5.REMOVE ROOF ANTENNA ASSEMBLY WITH COVER
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
86300J 6.REMOVE ROOF ANTENNA ASSEMBLY
| *A | When reusing the roof antenna assembly | - | - |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |