| *A | for 1GR-FE | - | - |
| *1 | ENGINE SIDE COVER SUB-ASSEMBLY LH | *2 | ENGINE SIDE COVER SUB-ASSEMBLY RH |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 6 | WHEEL ASSEMBLY | - | - | - | - |
| 7 | QUARTER PANEL REAR MUDGUARD RH | 76625G | - | - | - |
| 8 | REAR BUMPER SIDE SEAL RH | 52591 | ( ) |
- | - |
| 9 | REAR WHEEL HOUSE LINER RH | 65637B | - | - | - |
| *A | w/ Rear No. 2 Seat | *B | w/o Rear No. 2 Seat |
| *C | w/ Tonneau Cover | - | - |
| *A | w/ Rear No. 2 Seat | *B | w/ Rear No. 2 Seat, Curtain Shield Airbag |
| *C | w/ Tonneau Cover | - | - |
| ● | Non-reusable part | - | - |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 34 | REAR BUMPER ASSEMBLY | - | - | - | - |
| 35 | NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR | 58723B | - | - | - |
| 36 | NO. 4 COOLER UNIT DRAIN HOSE | 88539N | - | - | - |
| *A | w/ Rear No. 2 Seat | *B | w/ Tonneau Cover |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 46 | REAR NO. 1 SEAT PROTECTOR | 71695S | - | - | - |
| 47 | REAR NO. 2 SEAT PROTECTOR | 71695T | - | - | - |
| 48 | REAR NO. 3 SEAT PROTECTOR | 71695Y | - | - | - |
| 49 | REAR NO. 4 SEAT PROTECTOR | 71F95 | - | - | - |
| 50 | FRONT FLOOR CARPET ASSEMBLY | 58510D | - | - | - |
| 51 | REAR NO. 4 SIDE AIR DUCT | 87217G | - | - | - |
| 52 | REAR NO. 6 SIDE AIR DUCT | 87217K | - | - | - |
| 53 | REAR NO. 7 AIR DUCT | 87212L | - | - | - |
| *A | w/ Spacer | *B | w/ Rear No. 2 Seat, Curtain Shield Airbag |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air conditioning blower assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
When removing the damper servo sub-assembly, reinstallation is easier to perform if the following conditions are set before disconnecting the negative (-) battery terminal.
| Item | Condition |
|---|---|
| Air vent damper position | FACE |
| Set temperature | MAX HOT |
53292A 1.REMOVE UPPER RADIATOR SUPPORT SEAL
for Standard:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Standard)>REMOVAL
for Aero Type:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Aero Type)>REMOVAL
2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
51410 3.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
for 1GR-FE:
Click hereEngine / Hybrid System>1GR-FE (LUBRICATION)>OIL LEVEL SENSOR>REMOVAL
for V35A-FIS:
Click hereEngine / Hybrid System>V35A-FTS (LUBRICATION)>OIL PAN AND OIL LEVEL SENSOR>REMOVAL
51420 4.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY (for 1GR-FE)
5.DRAIN ENGINE COOLANT
for 1GR-FE:
for V35A-FIS:
6.REMOVE WHEEL ASSEMBLY
76625G 7.REMOVE QUARTER PANEL REAR MUDGUARD RH
Use the same procedure described for the LH side.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>MUDGUARD (for Rear)>REMOVAL
52591 8.REMOVE REAR BUMPER SIDE SEAL RH
Using a 4 mm hexagon socket wrench, remove the screw.
Remove the 3 clips and rear bumper side seal RH.
65637B 9.REMOVE REAR WHEEL HOUSE LINER RH
|
Remove in this Direction | - | - |
10.REMOVE REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)
Use the same procedure described for the LH side.
for Manual Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Manual Seat)>REMOVAL
for Power Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Power Seat)>REMOVAL
64910M 11.REMOVE TONNEAU COVER ASSEMBLY (w/o Rear No. 2 Seat, w/ Tonneau Cover)
58410B 14.REMOVE DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)
58418H 15.REMOVE REAR FLOOR BOARD REAR LH (w/o Rear No. 2 Seat)
58417B 16.REMOVE REAR FLOOR BOARD REAR RH (w/o Rear No. 2 Seat)
Use the same procedure described for the LH side.
64993 17.REMOVE REAR DECK FLOOR BOX (w/o Rear No. 2 Seat)
58574G 18.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/o Rear No. 2 Seat)
73233 19.REMOVE OUTER LAP BELT ANCHOR COVER
73360C 20.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR)
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT BELT>REAR NO. 1 SEAT OUTER BELT ASSEMBLY>REMOVAL
73560 21.REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR) (w/ Rear No. 2 Seat)
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT BELT>REAR NO. 1 SEAT OUTER BELT ASSEMBLY>REMOVAL
67917C 22.REMOVE REAR DOOR SCUFF PLATE RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62510M 24.REMOVE QUARTER TRIM PANEL ASSEMBLY RH
62471A 25.REMOVE INNER ROOF SIDE GARNISH RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
82161 26.DISCONNECT FLOOR WIRE
27.REMOVE COOLER PLATE
87217N 28.REMOVE REAR NO. 9 SIDE AIR DUCT
|
Remove in this Direction | - | - |
87245H 29.DISCONNECT INLET HEATER WATER HOSE H
Using pliers, grip the claws of the clip and slide the clip to disconnect the inlet heater water hose H.
Do not apply excessive force to the inlet heater water hose H.
Prepare a drain pan or cloth in case the coolant leaks.
87246G 30.DISCONNECT OUTLET HEATER WATER HOSE G
Using pliers, grip the claws of the clip and slide the clip to disconnect the outlet heater water hose G.
Do not apply excessive force to the outlet heater water hose G.
Prepare a drain pan or cloth in case the coolant leaks.
88G16N 31.DISCONNECT NO. 2 LIQUID TUBE
Remove the bolt and No. 2 liquid tube.
Remove the O-ring from the No. 2 liquid tube.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88717Z 32.DISCONNECT NO. 2 SUCTION TUBE
Remove the bolt and No. 2 suction tube.
Remove the O-ring from the No. 2 suction tube.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
87030 33.REMOVE AIR CONDITIONING BLOWER ASSEMBLY
34.REMOVE REAR BUMPER ASSEMBLY
Perform this procedure only when replacement of the No. 4 cooler unit Drain hose is necessary.
for Standard:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (for Standard)>REMOVAL
for Aero Type:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (for Aero Type)>REMOVAL
58723B 35.REMOVE NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Perform this procedure only when replacement of the No. 4 cooler unit Drain hose is necessary.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (for Standard)>DISASSEMBLY
88539N 36.REMOVE NO. 4 COOLER UNIT DRAIN HOSE
Perform this procedure only when replacement of the No. 4 cooler unit Drain hose is necessary.
37.REMOVE REAR NO. 2 SEAT ASSEMBLY LH (w/ Rear No. 2 Seat)
for Manual Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Manual Seat)>REMOVAL
for Power Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Power Seat)>REMOVAL
73233 38.REMOVE OUTER LAP BELT ANCHOR COVER
73370C 39.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR)
73570 40.REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR) (w/ Rear No. 2 Seat)
67918D 41.REMOVE REAR DOOR SCUFF PLATE LH
62520B 43.REMOVE QUARTER TRIM PANEL ASSEMBLY LH
44.REMOVE REAR NO. 1 SEAT ASSEMBLY RH
for 60/40 Split Seat Type RH Side:
Click hereVehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)>REMOVAL
for 40/20/40 Split Seat Type RH Side:
Click hereVehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 40/20/40 Split Seat Type RH Side)>REMOVAL
45.REMOVE REAR NO. 1 SEAT ASSEMBLY LH
71695S 46.REMOVE REAR NO. 1 SEAT PROTECTOR
71695T 47.REMOVE REAR NO. 2 SEAT PROTECTOR
71695Y 48.REMOVE REAR NO. 3 SEAT PROTECTOR
Use the same procedure as for the rear No. 1 seat protector.
71F95 49.REMOVE REAR NO. 4 SEAT PROTECTOR
Use the same procedure as for the rear No. 1 seat protector.
58510D 50.REMOVE FRONT FLOOR CARPET ASSEMBLY
|
Remove in this Direction | - | - |
87217G 51.REMOVE REAR NO. 4 SIDE AIR DUCT
87217K 52.REMOVE REAR NO. 6 SIDE AIR DUCT
87212L 53.REMOVE REAR NO. 7 AIR DUCT
54.REMOVE ROOF HEADLINING ASSEMBLY
62170A 55.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH (w/ Rear No. 2 Seat, Curtain Shield Airbag)
62495B 56.REMOVE NO. 2 ROOF SIDE INNER GARNISH SPACER RH (w/ Spacer)
88566S 57.REMOVE REAR NO. 2 ROOF AIR DUCT
88566U 58.REMOVE REAR NO. 4 ROOF AIR DUCT
88566T 59.REMOVE REAR NO. 3 ROOF AIR DUCT
88566R 60.REMOVE REAR NO. 1 ROOF AIR DUCT