| *A | for Dome Type | *B | for Spot Type |
| *C | w/o Overhead Console | *D | w/ Overhead Console |
| *E | for Bulb Type | *F | for LED Type |
| *1 | NO. 1 ROOM LIGHT LENS | *2 | NO. 2 ROOM LIGHT LENS |
81240 1.REMOVE NO. 1 ROOM LIGHT ASSEMBLY (for Dome Type)
for Bulb Type, w/o Overhead Console:
Using a thin-bladed screwdriver, detach the claw and guide and remove the No. 1 room light lens.
Tape the thin-bladed screwdriver tip before use.
Using a thin-bladed screwdriver, detach the claw.
Using a thin-bladed screwdriver, detach the claw and clamp and remove the No. 1 room light assembly.
for Bulb Type, w/ Overhead Console:
Using a thin-bladed screwdriver, detach the claw and guide and remove the No. 1 room light lens.
Tape the thin-bladed screwdriver tip before use.
Using a thin-bladed screwdriver, detach the claw.
Using a thin-bladed screwdriver, detach the claw and clamp and remove the No. 1 room light assmbly.
81240B 2.REMOVE NO. 1 ROOM LIGHT BULB (for Dome Type)
81360T 3.REMOVE SPOT LIGHT ASSEMBLY (for Spot Type)
for LED Type:
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Remove in this Direction (3) | - | - |
Using moulding remover D, detach the claw as shown in the illustration.
Using moulding remover D, detach the claw as shown in the illustration.
Detach the claw as shown in the illustration.
Disconnect the connector and remove the spot light assembly.
for Bulb Type:
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Remove in this Direction (3) | - | - |
Using moulding remover D, detach the claw as shown in the illustration.
Using moulding remover D, detach the claw as shown in the illustration.
Detach the claw as shown in the illustration.
Detach the claw and remove the spot light assembly.
81360U 4.REMOVE SPOT LIGHT BULB (for Spot Type)
81240D 5.REMOVE NO. 2 ROOM LIGHT ASSEMBLY
for LED Type:
|
Remove in this Direction | - | - |
Using moulding remover D, detach the claw and guide.
Detach the claw and guide as shown in the illustration.
Detach the clamp, disconnect the connector and remove the No. 2 room light assembly.
for Bulb Type, w/o Overhead Console:
Use the same procedure described for the No. 1 room light assembly.
for Bulb Type, w/ Overhead Console:
Use the same procedure described for the No. 1 room light assembly.
81240E 6.REMOVE NO. 2 ROOM LIGHT BULB