Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY
RM38G0E _58 Vehicle Interior _100751 SUPPLEMENTAL RESTRAINT SYSTEMS _0467876 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B612019N01
6.646,0.188 6.896,0.188 true 4.823,0.76 5.073,0.76 true 5.594,2.646 5.844,2.646 true 5.542,3.438 5.854,3.438 true 4.802,2.177 4.802,2.427 true 6.51,0.021 6.792,0.375 0.281,0.354 18 false 1 5.094,0.604 5.375,0.958 0.281,0.354 18 false 2 5.448,2.479 5.729,2.833 0.281,0.354 18 false 3 6.125,3.281 6.406,3.635 0.281,0.354 18 false 4 4.74,1.906 5.021,2.26 0.281,0.354 18 false 5 4.26,3.229 4.719,3.427 0.458,0.198 10 false x 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 INSTRUMENT PANEL SAFETY PAD ASSEMBLY - - - -
3 NO. 2 INSTRUMENT PANEL WIRE 82142 - - -
4 NO. 2 INSTRUMENT PANEL WIRE 82142A (Click here) - -
5 INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY 73960A (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the instrument panel passenger airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click here(Click here)



Hide 2.REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

Hide 82142 3.REMOVE NO. 2 INSTRUMENT PANEL WIRE

a.
B609321


Hide 82142A 4.REMOVE NO. 2 INSTRUMENT PANEL WIRE

a.
B609322N01
4.74,0.323 5.021,0.677 0.281,0.354 18 false i 3.771,0.104 4.052,0.458 0.281,0.354 18 false ii 2.698,0.271 2.979,0.625 0.281,0.354 18 false ii

i.

Disengage the claw.


ii.

Disconnect the 2 airbag connectors to remove the No. 2 instrument panel wire.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR




Hide 73960A 5.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

Z101186

CAUTION:
·
B528869N01
0.896,1.406 1.469,1.406 false 0.719,1.323 1.031,1.521 0.313,0.198 10 false *a

When storing the instrument panel passenger airbag assembly, keep the airbag deployment side (*a) facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.




a.
B593382N02
0.302,0.875 0.583,1.229 0.281,0.354 18 false i 3.74,0.177 4.021,0.531 0.281,0.354 18 false ii 3.729,2.25 4.01,2.604 0.281,0.354 18 false iii

i.

Remove the 2 screws.


ii.

Lean the instrument panel safety pad assembly and disengage the hook.


iii.

Disengage the hook to remove the instrument panel passenger airbag assembly.