| *A | w/ Child Restraint System Guide | - | - |
| *1 | RIVET | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear seat airbag assembly RH removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
|
|
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
|
|
for 1GR-FE:
for V35A-FTS:
72996H 3.REMOVE REAR SEATBACK COVER (w/ Child Restraint System Guide)
71701A 4.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY RH
| *A | w/ Child Restraint System Guide | - | - |
71751D 5.REMOVE REAR SEAT COVER HANGER
| *a | J Hook A | *b | J Hook B |
| *a | J Hook A | *b | J Hook B |
|
Remove in this Direction | - | - |
71251 6.REMOVE REAR SEATBACK FRAME RH
Disconnect the airbag connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR
Disengage the clamp.
Remove the 2 nuts and rear seatback frame RH.
73930A 7.REMOVE REAR SEAT AIRBAG ASSEMBLY RH
|
|
Remove the 2 nuts and rear seat airbag assembly RH.
Do not reuse the nut.
If the installation surface or surrounding area of the rear seat airbag assembly RH is deformed or damaged, replace the rear seatback frame RH, No. 1 seatback pad RH and No. 1 seatback cover sub-assembly RH.