Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM38G0E _58 Vehicle Interior _100751 SUPPLEMENTAL RESTRAINT SYSTEMS _0467922 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B009E84  Right Side Restraints Sensor 5 Signal Below Allowable Range  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority Test Mode / Check Mode
B009E84 Right Side Restraints Sensor 5 Signal Below Allowable Range Either condition is met:
·

A side airbag pressure sensor RH malfunction.

·

An airbag ECU assembly malfunction.


·

Side airbag pressure sensor RH

·

Airbag ECU assembly


Comes on SRS Airbag A Not applicable

WIRING DIAGRAM

C450171E31
1.594,0.677 1.75,0.875 0.156,0.198 10 false 2 1.583,1.479 1.74,1.677 0.156,0.198 10 false 1 2.854,0.656 3.01,0.854 0.156,0.198 10 false 1 2.844,1.479 3,1.677 0.156,0.198 10 false 2 4.146,0.667 4.302,0.865 0.156,0.198 10 false 4 5.333,0.656 5.646,0.854 0.313,0.198 10 false 26 5.365,1.479 5.677,1.677 0.313,0.198 10 false 25 4.177,1.49 4.333,1.688 0.156,0.198 10 false 3 5.635,0.792 6.25,0.99 0.615,0.198 10 false BBR+ 5.635,1.573 6.25,1.771 0.615,0.198 10 false BBR- 0.094,2.219 0.406,2.417 0.313,0.198 10 false M15 0.094,2.365 2.229,2.583 2.135,0.219 10 false Side Airbag Pressure Sensor RH 2.385,2.208 2.698,2.406 0.313,0.198 10 false Q2 2.385,2.375 5.25,2.698 2.865,0.323 10 false No. 2 Side Airbag Sensor Assembly RH 5.385,2.208 6,2.406 0.615,0.198 10 false Q1 5.385,2.365 6.854,2.677 1.469,0.313 10 false Airbag ECU Assembly 3.073,0.781 3.688,0.979 0.615,0.198 10 false BDR+ 3.083,1.573 3.698,1.771 0.615,0.198 10 false BDR- 3.615,0.781 4.229,0.979 0.615,0.198 10 false BCR+ 3.646,1.583 4.26,1.781 0.615,0.198 10 false BCR- 1.094,0.781 1.708,0.979 0.615,0.198 10 false BDR+ 1.083,1.604 1.698,1.802 0.615,0.198 10 false BDR-

CAUTION / NOTICE / HINT

NOTICE:
·

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When disconnecting and reconnecting the battery

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


·

After replacing the airbag ECU assembly, refer to initialization.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE



PROCEDURE

1.CHECK SIDE AIRBAG PRESSURE SENSOR RH
a.
B529883C12
0.969,1.521 1.24,1.719 0.271,0.198 10 false *1 2.323,1.531 2.594,1.729 0.271,0.198 10 false *2 1.646,1.271 1.917,1.469 0.271,0.198 10 false *3
*1 Side Airbag Pressure Sensor LH
*2 No. 2 Side Airbag Sensor Assembly RH
*3 Wire Harness


Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 60 seconds.


c.

Interchange the side airbag pressure sensor RH with LH and connect the connectors.


d.

Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.


e.

Turn the ignition switch to ON, and wait for at least 60 seconds.


f.

Clear the DTCs stored in memory.

Body Electrical > SRS Airbag > Clear DTCs
50002 444

Result:
Proceed to
NEXT



NEXT

2.CHECK SIDE AIRBAG PRESSURE SENSOR RH
2.CHECK SIDE AIRBAG PRESSURE SENSOR RH

Pre-procedure1

a.

Turn the ignition switch off.


b.

Turn the ignition switch to ON, and wait for at least 60 seconds.


Procedure1

c.

Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes
50001 444
Result:
Result Proceed to
DTC B009E84 is output A
DTC B009B84 is output B
DTC B009B84 and B009E84 are not output C



Post-procedure1

HINT:

Codes other than DTCs B009B84 and B009E84 may be output at this time, but they are not related to this check.


d.

Turn the ignition switch off.


e.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 60 seconds.


f.

Return the side airbag pressure sensor LH and RH to their original positions and connect the connectors.



A

B

C