Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR (for Front Door) › 2021.04–2021.07
RM38G0E _58 Vehicle Interior _100751 SUPPLEMENTAL RESTRAINT SYSTEMS _0467877 SIDE AIRBAG SENSOR(for Front Door) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR(for Front Door)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B612028N01
0.083,0.583 0.75,1.667 0.667,1.083 1,0.583 1.667,1.667 0.667,1.083 2.25,3.292 3.333,3.75 1.083,0.458 1.083,3.292 2.167,3.75 1.083,0.458 0.083,3.292 1,3.75 0.917,0.458 6.542,0.604 6.792,0.604 true 6.583,0.198 6.833,0.198 true 5.167,2.313 5.167,2.563 true 3.979,1.365 3.979,1.604 true 2.969,0.479 2.969,0.719 true 0.5,3.583 0.75,3.583 true 3.552,3.292 3.552,3.542 true 2.104,2.688 2.354,2.688 true 1.469,1.125 1.469,1.406 true 0.542,1.167 0.542,1.417 true 1.677,2.854 1.927,2.854 true 1.698,3.583 1.958,3.583 true 2.896,3.583 3.146,3.583 true 6.448,0.031 6.729,0.385 0.281,0.354 18 false 1 6.385,0.438 6.667,0.792 0.281,0.354 18 false 2 1.521,2.698 1.802,3.052 0.281,0.354 18 false 3 1.396,1.365 1.677,1.719 0.281,0.354 18 false 4 0.469,1.375 0.75,1.729 0.281,0.354 18 false 5 2.906,0.219 3.188,0.573 0.281,0.354 18 false 6 0.354,3.427 0.635,3.708 0.281,0.281 18 false 7 3.833,1.104 4.229,1.458 0.396,0.354 18 false 12 5.031,2.51 5.385,2.854 0.354,0.344 18 false 13 1.99,2.198 2.448,2.396 0.458,0.198 10 false x 2 1.052,0.604 1.427,0.844 0.375,0.24 12 false *A 0.125,3.302 0.5,3.542 0.375,0.24 12 false *C 0.135,0.604 0.51,0.844 0.375,0.24 12 false *B 1.802,2.521 2.156,2.865 0.354,0.344 18 false 10 3.417,3.5 3.771,3.792 0.354,0.292 18 false 11 2.281,3.302 2.656,3.542 0.375,0.24 12 false *D 1.125,3.302 1.5,3.542 0.375,0.24 12 false *E 1.542,3.427 1.823,3.708 0.281,0.281 18 false 8 2.729,3.427 3.01,3.708 0.281,0.281 18 false 9 3.292,1.625 3.75,1.823 0.458,0.198 10 false x 3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL - (Click here) - -
3 FRONT DOOR TRIM UPPER COVER 67782 (Click here) - -
4 MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL - (Click here) - -
5 POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL - (Click here) - -
6 FRONT DOOR ARMREST COVER LH 74222A (Click here) - -
7 COURTESY LIGHT ASSEMBLY 81230 - - -
8 REFLEX REFLECTOR ASSEMBLY 81580C (Click here) - -
9 FRONT DOOR HOLE COVER 67811C (Click here) - -
10 NO. 1 FRONT DOOR STIFFENER CUSHION 67923E - - -
11 FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH 67602 - - -
12 FRONT DOOR SERVICE HOLE COVER LH 67832 (Click here) - -
13 SIDE AIRBAG PRESSURE SENSOR LH 8983AA (Click here) - -

*A for Driver Side *B for Front Passenger Side
*C w/ Courtesy Light *D w/ Cover
*E w/ Reflex Reflector Assembly - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the side airbag pressure sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





Hide 67782 3.REMOVE FRONT DOOR TRIM UPPER COVER

Z101186

Click here(Click here)

Hide 4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Z101186

Click here(Click here)

Hide 5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Z101186

Click here(Click here)

Hide 74222A 6.REMOVE FRONT DOOR ARMREST COVER LH

Z101186

Click here(Click here)

Hide 81230 7.REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

Hide 81580C 8.REMOVE REFLEX REFLECTOR ASSEMBLY (w/ Reflex Reflector Assembly)

Z101186

Click here(Click here)

Hide 67811C 9.REMOVE FRONT DOOR HOLE COVER (w/ Cover)

Z101186

Click here(Click here)

Hide 67923E 10.REMOVE NO. 1 FRONT DOOR STIFFENER CUSHION

Hide 67602 11.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 67832 12.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Z101186

Click here(Click here)

Hide 8983AA 13.REMOVE SIDE AIRBAG PRESSURE SENSOR LH

a.
B608600C01
0.583,0.667 1.167,0.667 true 4.208,0.094 4.531,0.417 0.323,0.323 18 false ii 0.438,0.563 0.708,0.771 0.271,0.208 10 false *a 0.625,0.094 0.948,0.417 0.323,0.323 18 false i
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B609496N01
1.094,0.615 1.375,0.969 0.281,0.354 18 false i 1.552,0.25 1.833,0.604 0.281,0.354 18 false ii 3.927,0.021 4.208,0.375 0.281,0.354 18 false iii

i.

Remove the nut.


ii.

Disengage the claw and pull out the side airbag pressure sensor LH.


iii.

Disconnect the airbag connector and remove the side airbag pressure sensor LH.

NOTICE:
·

When disconnecting any airbag connector, take care not to damage the airbag wire harness.

·

If the side airbag pressure sensor LH has been dropped, replace it with a new one.



HINT:

Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR