If the air conditioning system cannot be operated using the air conditioning control switch, the following factors may be the cause.
| Symptom | Factor |
|---|---|
| Air conditioning system cannot be operated using air conditioning control switch (With the exception of the switch indicators, no inputs are reflected when other switches operated) |
·
LIN communication malfunction between air conditioning amplifier assembly and air conditioning control assembly
·
LIN communication malfunction between air conditioning amplifier assembly and cooler control switch assembly (w/ Rear Air Conditioning System)
·
Short to +B or ground in air conditioning amplifier assembly circuit
·
Air conditioning amplifier assembly malfunction
·
Air conditioning control assembly malfunction
·
Cooler control switch assembly malfunction (w/ Rear Air Conditioning System)
·
Harness or connector |
Inspect the fuses for circuits related to this system before performing the following procedure.
| Result | Proceed to |
|---|---|
| Malfunction occurs front | A |
| Malfunction occurs rear | B |
A
B
Clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| B14B287 is not output | A |
| B14B287 is output | B |
A
B
Disconnect the I33 air conditioning amplifier assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I33)Location & Routingewd_type=routing;type=c;code=I33 |
||
| I33-5 (B) - Body ground | Always | 11 to 14 V |
| I33-6 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| I33-6 (IG+) - Body ground | Ignition switch off | Below 1 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I33)Location & Routingewd_type=routing;type=c;code=I33 |
||
| I33-5 (B) - Body ground | Always | 11 to 14 V |
| I33-6 (IG+) - Body ground | Ignition switch ON | 10.5 to 16 V |
| I33-6 (IG+) - Body ground | Ignition switch off | Below 1 V |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/o Stop and Start System) | B |
| NG (w/ Stop and Start System) | C |
A
B
C
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Disconnect the I33 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I33)Location & Routingewd_type=routing;type=c;code=I33 |
||
| I33-17 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| B14B387 is not output | A |
| B14B387 is output | B |
A
B
Disconnect the I31 and I33 air conditioning amplifier assembly connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I31,I33)Location & Routingewd_type=routing;type=c,c;code=I31,I33 |
||
| I31-1 (+B2) - Body ground | Always | 11 to 14 V |
| I33-6 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| I33-6 (IG+) - Body ground | Ignition switch off | Below 1 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I31,I33)Location & Routingewd_type=routing;type=c,c;code=I31,I33 |
||
| I31-1 (+B2) - Body ground | Always | 11 to 14 V |
| I33-6 (IG+) - Body ground | Ignition switch ON | 10.5 to 16 V |
| I33-6 (IG+) - Body ground | Ignition switch off | Below 1 V |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/o Stop and Start System) | B |
| NG (w/ Stop and Start System) | C |
A
B
C
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Disconnect the I31 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I31)Location & Routingewd_type=routing;type=c;code=I31 |
||
| I31-4 (GND2) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG