| *A | for 4 Zone Type | *B | for Dual Type |
| *1 | HEATER CASE (for Front Side) | *2 | HEATER CASE (for Rear Side) |
| ● | Non-reusable part |
|
Compressor oil ND-OIL 8 or equivalent |
| *A | w/ Cool Box | *B | w/o Cool Box |
| *C | for LHD | *D | for RHD |
| *1 | PIPING CLAMP | *2 | BRACKET |
| *3 | NO. 1 COOLER COVER | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
|
Compressor oil ND-OIL 8 or equivalent | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 16 | BLOWER ASSEMBLY | 87130D | - | - | - |
88625 1.INSTALL NO. 1 COOLER THERMISTOR
| *a | Fixed Part | *b | Sensor Part |
Install the No. 1 cooler thermistor as shown in the illustration.
| Part | Length |
|---|---|
| A | 108 mm (4.25 in.)(16 Fins) |
| B | 45 to 55 mm (1.77 to 2.17 in.) |
Be sure to insert the No. 1 cooler thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
After inserting the No. 1 cooler thermistor, do not apply excessive force to the wire.
When reusing the No. 1 cooler evaporator sub-assembly, insert the sensor part of the No. 1 cooler thermistor one row from the row that had been used previously (X in the illustration).
Directly insert the No. 1 cooler thermistor until the edge of the plastic case "a" comes into contact with the No. 1 cooler evaporator sub-assembly "b".
88501 2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
87050F 3.INSTALL NO. 4 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
87050D 4.INSTALL NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
82210K 5.CONNECT AIR CONDITIONING HARNESS ASSEMBLY
87201B 6.INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY (for LHD)
88515 7.INSTALL COOLER EXPANSION VALVE (w/o Cool Box)
88892N 9.INSTALL NO. 2 COOLER COVER (w/o Cool Box)
88710A 10.INSTALL AIR CONDITIONING TUBE ASSEMBLY (w/ Cool Box)
87107A 11.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY
87124B 12.INSTALL HEATER CLAMP
87201B 13.INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY (for RHD)
88898D 14.INSTALL GROMMET
87128B 15.INSTALL NO. 2 HEATER GROMMET
87130D 16.INSTALL BLOWER ASSEMBLY