| *A | for Driver Side | *B | for Front Passenger Side |
| *C | w/ Courtesy Light | *D | w/ Cover |
| *E | w/ Reflex Reflector Assembly | - | - |
| *1 | GROMMET | - | - |
| ● | Non-reusable part | - | - |
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
2.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
3.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
67923E 8.REMOVE NO. 1 FRONT DOOR STIFFENER CUSHION
67602 9.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
89430A 10.REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY LH
|
Remove in this Direction | - | - |
Using a thin-bladed screwdriver, detach the claw and remove the connector clamp as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
Remove the 2 screws and outer mirror control ECU assembly.
Disconnect the 2 connectors.
Detach the claw and remove the 2 grommets.