| *A | w/ Power Back Door | *B | w/o Power Back Door |
| ● | Non-reusable part | - | - |
67939B 1.REMOVE BACK DOOR CENTER GARNISH
2.REMOVE HOLE PLUG
w/ Power Back Door:
w/o Power Back Door:
64886B 3.REMOVE BACK DOOR GLASS CHANNEL LH (w/o Power Back Door)
|
|
| Part | Temperature |
|---|---|
| Back Door Glass Channel LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the back door glass channel LH excessively.
|
Double-sided Tape | - | - |
Remove the clip.
Heat the adhesive of the back door glass channel LH using a heat light.
Detach the claw of the back door glass channel LH, double sided-tape and remove the back door glass channel LH.
64885C 4.REMOVE BACK DOOR GLASS CHANNEL RH (w/o Power Back Door)
Use the same procedure described for LH side.
76085 5.REMOVE REAR SPOILER SUB-ASSEMBLY
Disconnect the washer hose.
Remove the 6 bolts.
Put protective tape around the rear spoiler sub-assembly.
|
Place Hand Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Remove in this Direction (3) |
Place your hand at the position shown in the illustration, pull upward to detach the clip on the left side of the rear spoiler sub-assembly.
Place your hand at the position shown in the illustration, pull upward to detach the clip on the right side of the rear spoiler sub-assembly.
Place your hands at the positions shown in the illustration, detach the clip at the center of the rear spoiler sub-assembly and remove the rear spoiler sub-assembly.