| *A | for Type A | - | - |
| *1 | ROOF CARRIER LH | - | - |
| ● | Non-reusable part | ★ | Precoated part |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 6 | ROOF HEADLINING ASSEMBLY | - | - | - | - |
| 7 | CURTAIN SHIELD AIRBAG ASSEMBLY LH | 62180A | - | - | - |
| 8 | ROOF RACK ASSEMBLY LH | 63470B | ( ) |
- | - |
| 9 | NO. 2 ROOF CARRIER SEAL | 63437A | ( ) |
- | - |
| *A | for Type B | *B | w/ Curtain Shield Airbag |
| *C | w/o Curtain Shield Airbag | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the roof rack assembly LH removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
63492 1.REMOVE FRONT ROOF RACK LEG COVER LH (for Type A)
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
63496 2.REMOVE CENTER ROOF RACK LEG COVER LH (for Type A)
|
Remove in this Direction | - | - |
63494 3.REMOVE REAR ROOF RACK LEG COVER LH (for Type A)
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
63408C 4.REMOVE ROOF CARRIER SUB-ASSEMBLY LH (for Type A)
63437A 5.REMOVE NO. 2 ROOF CARRIER SEAL (for Type A)
|
|
| Part | Temperature |
|---|---|
| No. 2 Roof Carrier Seal | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the No. 2 roof carrier seal excessively.
Heat the adhesive of the No. 2 roof carrier seal using a heat light.
Remove the 4 No. 2 roof carrier seals.
6.REMOVE ROOF HEADLINING ASSEMBLY (for Type B, w/o Curtain Shield Airbag)
62180A 7.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (for Type B, w/ Curtain Shield Airbag)
63470B 8.REMOVE ROOF RACK ASSEMBLY LH (for Type B)
Put protective tape around the roof rack assembly LH.
Remove the 5 nuts.
Detach the claw and guide and remove the roof rack assembly LH.
63437A 9.REMOVE NO. 2 ROOF CARRIER SEAL (for Type B)
|
|
| Part | Temperature |
|---|---|
| No. 2 Roof Carrier Seal | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the No. 2 roof carrier seal excessively.
Heat the adhesive of the No. 2 roof carrier seal using a heat light.
Remove the 5 No. 2 roof carrier seals.