Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD (for Roof)
RM38G0E _56 Audio / Visual / Telematics _100606 AUDIO / VIDEO _0468137 RADIO ANTENNA CORD(for Roof) A

AUDIO / VIDEO  RADIO ANTENNA CORD(for Roof)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E462460N01
6.49,0.188 6.771,0.188 false 4.542,2 4.854,2.792 4.854,2.792 5.188,2.792 false 6.323,0.042 6.479,0.354 0.156,0.313 18 false 1 5.25,2.625 5.438,2.927 0.188,0.302 18 false 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 ROOF HEADLINING ASSEMBLY - - - -

E462462N01
2.115,0.635 2.635,0.635 false 2.083,1.354 2.208,1.667 2.208,1.667 2.542,1.667 false 5.375,1.313 5.5,1.625 5.5,1.625 5.833,1.625 false 4.906,0.677 5.427,0.677 false 1.01,1.313 1.25,1.313 false 0.073,0.156 0.448,0.396 0.375,0.24 12 false *A 3.573,0.156 3.948,0.396 0.375,0.24 12 false *B 2.792,0.479 2.979,0.771 0.188,0.292 18 false 3 2.604,1.542 2.792,1.813 0.188,0.271 18 false 4 5.438,0.583 5.677,0.813 0.24,0.229 10 false *1 1.281,1.188 1.521,1.417 0.24,0.229 10 false *1 2.677,0.542 2.833,0.74 0.156,0.198 10 false ● 5.885,1.458 6.073,1.729 0.188,0.271 18 false 4

Procedure Part Name Code
Z101186

Z101188

Z101187

3 NO. 2 ROOF SILENCER PAD 63342 - - -
4 NO. 2 ANTENNA CORD SUB-ASSEMBLY 86101J - - -

*A for Normal Roof *B for Moon Roof
*1 WASHER HOSE ASSEMBLY - -
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the No. 2 antenna cord sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click here(Click here)



Hide 2.REMOVE ROOF HEADLINING ASSEMBLY

Hide 63342 3.REMOVE NO. 2 ROOF SILENCER PAD (for Normal Roof)

Hide 86101J 4.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

a.
E462463C01
0.406,0.24 0.688,0.521 0.281,0.281 12 false *A 3.74,0.229 4.052,0.469 0.313,0.24 12 false *B 0.115,0.031 0.396,0.385 0.281,0.354 18 false i
*A for Normal Roof *B for Moon Roof


i.

Detach the guide and remove the washer hose assembly.



b.
E462464C01
1.698,1.354 1.854,1.573 1.854,1.573 1.979,1.354 true 1.688,3.354 1.844,3.573 1.844,3.573 1.969,3.354 true 2.563,3.167 2.865,3.521 2.865,3.521 3.063,3.24 true 2.24,1.542 2.125,1.156 true 6.135,1.5 6.281,1.167 true 6.156,3.51 6.302,3.177 true 3.365,3.51 3.365,3.208 true 2.25,3.552 2.125,3.156 true 0.448,0.167 0.729,0.375 0.281,0.208 12 false *A 0.49,1.927 0.771,2.146 0.281,0.219 12 false *B 1.781,3.573 2.01,3.781 0.229,0.208 10 false *a 6.073,3.521 6.302,3.729 0.229,0.208 10 false *a 2.188,3.594 2.417,3.802 0.229,0.208 10 false *a 1.771,1.594 2,1.802 0.229,0.208 10 false *a 2.198,1.583 2.427,1.792 0.229,0.208 10 false *a 0.125,0.042 0.427,0.302 0.302,0.26 18 false i 2.802,3.542 3.031,3.75 0.229,0.208 10 false *b 3.281,3.542 3.51,3.75 0.229,0.208 10 false *b 6.031,1.542 6.26,1.75 0.229,0.208 10 false *a 0.104,1.948 0.406,2.208 0.302,0.26 18 false ii
*A for Normal Roof *B for Moon Roof
*a Clamp *b Guide


i.

for Normal Roof:

1. Detach the clamp and remove the No. 2 antenna cord sub-assembly.


ii.

for Moon Roof:

1. Detach the clamp and guide and remove the No. 2 antenna cord sub-assembly.