| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 2 ROOF SILENCER PAD | 63342 | - | - | - |
| 2 | NO. 1 ROOF SILENCER PAD | 63341 | - | - | - |
| 3 | NO. 4 ROOF SILENCER PAD | 63344 | - | - | - |
| 4 | OUTLET AIR GRILLE ASSEMBLY | 88570E | - | - | - |
| *A | for Normal Roof | *B | for Moon Roof |
| *C | w/ Rear Cooler | - | - |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 5 | OUTLET AIR GRILLE LH | 88571B | - | - | - |
| 6 | OUTLET AIR GRILLE RH | 88571A | - | - | - |
| 7 | OUTLET NO. 2 AIR GRILLE ASSEMBLY | 88570D | - | - | - |
| 8 | OUTLET NO. 1 AIR GRILLE ASSEMBLY | 88570B | - | - | - |
| 9 | NO. 30 CONNECTOR HOLDER | 82667S | - | - | - |
| 10 | TELEPHONE MICROPHONE ASSEMBLY | 86730A | - | - | - |
| 11 | ACTIVE NOISE CONTROL MICROPHONE | 86734D | - | - | - |
| 12 | ROOF HEADLINING HOLDER COVER | 63388A | - | - | - |
| 13 | NO. 2 ROOF HEADLINING HOLDER COVER | 63388G | - | - | - |
| *A | w/ Active Noise Control System | *B | w/o Microphone, for Driver Side |
| *C | w/ Microphone | *D | w/ Rear Cooler |
| *E | for Front Passenger Side | - | - |
| *1 | Cable Tie | - | - |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 14 | NO. 2 ANTENNA CORD SUB-ASSEMBLY | 86101J | - | - | - |
| 15 | WASHER HOSE | - | - | - | - |
| 16 | NO. 1 ROOF WIRE | 82171 | ( ) |
- | - |
| *A | for Normal Roof | *B | for Moon Roof |
| *A | for LH Side | *B | w/ Tonneau Cover |
| *C | w/ Rear No. 2 Seat | *D | w/ Rear Airconditioning System |
| *E | w/o Woofer | - | - |
| *1 | Spring Nut | - | - |
| ● | Non-reusable part | - | - |
| *A | for RH Side | *B | w/ Tonneau Cover |
| *C | w/ Rear No. 2 Seat | *D | w/ Rear Airconditioning System |
| *1 | Spring Nut | - | - |
| ● | Non-reusable part | - | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
63342 1.REMOVE NO. 2 ROOF SILENCER PAD (for Normal Roof)
63341 2.REMOVE NO. 1 ROOF SILENCER PAD
63344 3.REMOVE NO. 4 ROOF SILENCER PAD
88570E 4.REMOVE OUTLET AIR GRILLE ASSEMBLY (w/ Rear Cooler)
Use the same procedure for the opposite side.
88571B 5.REMOVE OUTLET AIR GRILLE LH (w/ Rear Cooler)
88571A 6.REMOVE OUTLET AIR GRILLE RH (w/ Rear Cooler)
Use the same procedure described for the LH side.
88570D 7.REMOVE OUTLET NO. 2 AIR GRILLE ASSEMBLY (w/ Rear Cooler)
Use the same procedure for the other side.
88570B 8.REMOVE OUTLET NO. 1 AIR GRILLE ASSEMBLY (w/ Rear Cooler)
Use the same procedure described for the No. 2 air outlet grille assembly.
82667S 9.REMOVE NO. 30 CONNECTOR HOLDER
w/o Microphone, for Driver Side:
for Front Passenger Side:
Use the same procedure for the driver side.
86730A 10.REMOVE TELEPHONE MICROPHONE ASSEMBLY (w/ Microphone)
86734D 11.REMOVE ACTIVE NOISE CONTROL MICROPHONE (w/ Active Noise Control System)
63388A 12.REMOVE ROOF HEADLINING HOLDER COVER
Use the same procedure for the opposite side.
63388G 13.REMOVE NO. 2 ROOF HEADLINING HOLDER COVER
Use the same procedure for the other side.
86101J 14.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
15.REMOVE WASHER HOSE
for Normal Roof:
for Moon Roof:
82171 16.REMOVE NO. 1 ROOF WIRE
The illustrations are representative examples, and details may differ.
| *A | for Driver Side | *B | for Front Passenger Side |
|
Remove in this Direction | - | - |
Turn the visor connectors approximately 90° counterclockwise and remove them from the roof headlining assembly.
Detach the claw.
for Normal Roof, Dome Type:
| *A | for LHD | *B | for RHD |
|
Tape | - | - |
Remove each piece of tape.
Detach the clamp and remove the No. 1 roof wire from the roof headlining assembly.
for Normal Roof, Spot Type:
| *A | for LHD | *B | for RHD |
|
Tape | - | - |
Remove each piece of tape.
Detach the clamp and remove the No. 1 roof wire from the roof headlining assembly.
for Moon Roof:
| *A | for LHD | *B | for RHD |
|
Tape | - | - |
Remove each piece of tape.
Detach the clamp and remove the No. 1 roof wire from the roof headlining assembly.
87217H 17.REMOVE REAR NO. 5 SIDE AIR DUCT (w/ Rear Air Conditioning System)
82236 18.REMOVE NO. 2 ROOM WIRE
The illustrations are representative examples, and details may differ.
66992 19.REMOVE NO. 2 CUP HOLDER
62518B 20.REMOVE FRONT QUARTER TRIM BASE LH (w/ Tonneau Cover)
64934E 21.REMOVE FRONT TONNEAU COVER HOLDER BRACKET LH (w/ Tonneau Cover)
62606A 22.REMOVE QUARTER TRIM LID SUB-ASSEMBLY LH
62634D 23.REMOVE FRONT QUARTER TRIM BASE COVER LH (w/ Rear Air Conditioning System)
62636B 24.REMOVE REAR QUARTER TRIM BASE COVER LH (w/ Rear Air Conditioning System)
62598D 25.REMOVE SIDE TRIM BOX COVER (w/o Woofer)
87217F 26.REMOVE REAR NO. 3 SIDE AIR DUCT (w/ Rear Air Conditioning System)
82235 27.REMOVE ROOM WIRE
The illustrations are representative examples, and details may differ.
66991B 28.REMOVE NO. 1 CUP HOLDER
Use the same procedure described for the No. 2 cup holder.
62517B 29.REMOVE FRONT QUARTER TRIM BASE RH (w/ Tonneau Cover)
Use the same procedure described for the LH Side.
64933E 30.REMOVE FRONT TONNEAU COVER HOLDER BRACKET RH (w/ Tonneau Cover)
Use the same procedure described for the LH Side.
62538C 31.REMOVE QUARTER TRIM COVER HOLE
62633D 32.REMOVE FRONT QUARTER TRIM BASE COVER RH (w/ Rear Air Conditioning System)
Use the same procedure described for the LH Side.
62635B 33.REMOVE REAR QUARTER TRIM BASE COVER RH (w/ Rear Air Conditioning System)
Use the same procedure described for the LH Side.
73371A 34.REMOVE REAR SEAT SHOULDER BELT HANGER
| *a | Cut | - | - |
|
Remove in this Direction | - | - |
Using a plier nipper (side cutters), cut the rear seat shoulder belt hanger at the positions shown in the illustration.
Pull the rear seat shoulder belt hanger to remove the 2 spring nuts and rear seat shoulder belt hanger as shown in the illustration.
Use the same procedure for the other side.
73371H 35.REMOVE REAR NO. 2 SEAT SHOULDER BELT HANGER (w/ Rear No. 2 Seat)
Use the same procedure described for the rear seat shoulder belt hanger.