| *A | w/ Tonneau Cover | *B | w/ Curtain Shield Airbag |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
| ● | Non-reusable part | - | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
73570 1.INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH
| *a | Unlock | *b | Lock |
| *c | 45° | - | - |
|
Bolt A |
|
Bolt B |
When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
Do not disassemble the retractor.
Attach the guide.
Install the rear No. 2 seat outer belt assembly LH with the bolt B.
Tighten the bolt A and install the shoulder anchor of the rear No. 2 seat outer belt assembly LH.
62472A 2.INSTALL INNER ROOF SIDE GARNISH LH
62520B 3.INSTALL QUARTER TRIM PANEL ASSEMBLY LH
64937A 4.INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)
73570 5.INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR)
73370C 6.INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR)
73233D 7.INSTALL OUTER LAP BELT ANCHOR COVER
67918D 8.INSTALL REAR DOOR SCUFF PLATE LH
9.INSTALL REAR NO. 2 SEAT ASSEMBLY LH
for Manual Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Manual Seat)>INSTALLATION
for Power Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Power Seat)>INSTALLATION