| *A | w/ Tonneau Cover | *B | for RH Seat |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf) : Specified torque |
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
1.INSTALL REAR NO. 2 SEAT ASSEMBLY LH
| *A | w/ Seat Belt Warning System | - | - |
|
Install in this Direction |
|
Bolt |
|
Connector | - | - |
Insert the 2 location pins of the rear seat No. 2 asssembly LH through the 2 body holes and place the rear seat No. 2 asssembly LH.
2 or more people are required when carrying the rear No. 2 seat assembly LH into the vehicle.
Be careful not to damage the vehicle body.
When installing the rear No. 2 seat assembly RH only, take care not to turn up the center protector cover.
Install the 2 bolts in the order shown in the illustration.
w/ Seat Belt Warning System:
1. Connect the 2 connectors.
|
Bolt |
|
Clip |
Install the 2 bolts in the order shown in the illustration.
Install the 2 clips.
58458J 2.INSTALL NO. 3 DECK FLOOR BRACKET RH
58459B 3.INSTALL NO. 3 DECK FLOOR BRACKET LH
58574G 4.INSTALL REAR FLOOR MAT REAR SUPPORT PLATE
79959G 5.INSTALL NO. 2 SEAT NO. 1 LEG COVER RH (for RH Seat)
79959J 6.INSTALL NO. 2 SEAT NO. 1 LEG COVER LH
58417B 7.INSTALL REAR FLOOR BOARD REAR RH
58418H 8.INSTALL REAR FLOOR BOARD REAR LH
66310N 9.INSTALL ROPE HOOK ASSEMBLY
58410B 10.INSTALL DECK BOARD ASSEMBLY
64910M 11.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)