|
N*m (kgf*cm, ft.*lbf): Specified torque | ★ | Precoated part |
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
68948 1.INSTALL BACK DOOR DAMPER STAY LOWER BRACKET
| *a | Arrow mark | - | - |
|
Cleaning area | - | - |
Clean the bolt holes in the vehicle body.
When reusing a bolt:
1. Clean the threads of the bolts.
2. Apply a few drops of adhesive to 2 or 3 threads at the tip of each of the bolts.
Install the back door damper stay lower bracket with 2 bolts.
With the door closed, install the back door damper stay lower bracket so that the arrow marker is facing the top side of the vehicle.
68946 2.INSTALL BACK DOOR DAMPER STAY UPPER BRACKET
| *a | Arrow mark | - | - |
|
Cleaning area | - | - |
Clean the bolt holes in the vehicle body.
When reusing a bolt:
1. Clean the threads of the bolts.
2. Apply a few drops of adhesive to 2 or 3 threads at the tip of each of the bolts.
Install the back door damper stay upper bracket with 2 bolts.
With the door closed, install the back door damper stay upper bracket so that the arrow marker is facing the top side of the vehicle.
84280D 3.INSTALL POWER BACK DOOR SENSOR ASSEMBLY
68920 4.INSTALL POWER BACK DOOR UNIT ASSEMBLY SET
|
|
Engage the 2 ball joints to install the power back door unit assembly set.
Install the power back door unit assembly set while supporting the back door by hand.
Check that the power back door unit assembly set is engaged to the ball joints and that it cannot be pulled out.
Engage the clamp.
Connect the connector.
5.INSTALL REAR BUMPER ASSEMBLY
for Standard:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (for Standard)>INSTALLATION
for Aero Type:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (for Aero Type)>INSTALLATION
6. INITIALIZE POWER BACK DOOR SYSTEM
7.INSPECT POWER BACK DOOR SYSTEM