| *A | w/ Front Seat Side Airbag | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat assembly removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
If the front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback spring sub-assembly, front seatback pad and front seatback cover sub-assembly with the necessary parts in accordance with the extent of the collision damage.
Replace any other damaged parts as necessary.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1. PRECAUTION
|
|
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)
|
|
for 1GR-FE:
for V35A-FTS:
71910F 3.REMOVE FRONT SEAT HEADREST ASSEMBLY LH
72123M 4.REMOVE FRONT OUTER SEAT TRACK BRACKET COVER LH
|
Place Hands Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) | - | - |
Operate the seat track adjusting handle LH and move the front seat assembly LH to the rearmost position.
Using a thin-bladed screwdriver, detach the claw.
Tape the thin-bladed screwdriver tip before use.
Place your hands at the position shown in the illustration and slide in the removal direction (2) while pulling in the removal direction (1) to detach the guide and remove the front outer seat track bracket cover LH.
72123L 5.REMOVE FRONT INNER SEAT TRACK BRACKET COVER LH
Use the same procedure described for the front outer seat track bracket cover LH.
72137Y 6.REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH
| *a | Protective Tape | - | - |
|
Remove in this Direction | - | - |
72158F 7.REMOVE REAR INNER SEAT TRACK BRACKET COVER LH
Use the same procedure described for the rear outer seat track bracket cover LH.
8.REMOVE FRONT SEAT ASSEMBLY LH
| *A | for Driver Side | - | - |
Using a T50 "TORX" socket wrench, remove the 2 "TORX" screws.
Operate the seat track adjusting handle LH and move the front seat assembly LH to the rearmost position.
Using a T50 "TORX" socket wrench, remove the 2 "TORX" screws.
Operate the seat track adjusting handle LH and move the front seat assembly LH to the center position.
Operate the reclining adjuster release handle LH to set the seatback of the front seat assembly LH to the perpendicular position.
for Driver Side:
1. Operate the front seat vertical adjuster handle LH to set the seat cushion height to the highest position.
| *A | w/ Front Seat Side Airbag | - | - |
w/ Front Seat Side Airbag:
1. Disconnect the connector of the front seat airbag assembly LH.
Do not pull while holding the wire harness.
Refer to How to Connect or Disconnect Airbag Connector.
Disconnect the connector and detach the clamp under the front seat assembly LH to remove the floor wire harness.
Remove and carry the front seat assembly LH out of the vehicle.
Protect the front seat legs.
Carrying the front seat assembly LH from the vehicle must be performed by multiple people.
Do not damage the front seat assembly LH, body exterior or interior parts.