| *A | for Driver Side | *B | for Front Passenger Side |
| *1 | SEAT ADJUSTER SHIELD CLAMP BRACKET LH | - | - |
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
84922C 1.INSTALL FRONT POWER SEAT SWITCH LH
| *1 | Seat Adjuster Shield Clamp Bracket LH | - | - |
Align the guide and set the front power seat switch LH and seat adjuster shield clamp bracket LH to the front seat cushion shield LH.
Temporarily install the 4 screws.
Tighten the 4 screws in the order shown in the illustration and install the front power seat switch LH and seat adjuster shield clamp bracket LH.
When tightening the front power seat switch LH with the screws, do not apply any force other than in the tightening direction.
84921Q 2.INSTALL RECLINING POWER SEAT SWITCH KNOB
84921R 3.INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
71811T 4.INSTALL FRONT SEAT CUSHION SHIELD RH (for Front Passenger Side)
71812T 5.INSTALL FRONT SEAT CUSHION SHIELD LH (for Driver Side)
71867X 6.INSTALL FRONT SEAT FRONT CUSHION SHIELD LH
7.INSTALL FRONT SEAT ASSEMBLY LH