| *A | w/ Memory | *B | w/ Front Seat Side Airbag |
| *C | w/ Seat Heater System | *D | w/ Climate Control Seat System |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
72158F 1.INSTALL REAR INNER SEAT TRACK BRACKET COVER LH
72137Y 2.INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH
72123L 3.INSTALL FRONT INNER SEAT TRACK BRACKET COVER LH
72123M 4.INSTALL FRONT OUTER SEAT TRACK BRACKET COVER LH
5.INSTALL FRONT SEAT ASSEMBLY LH
Place the front seat assembly LH in the vehicle.
2 or more people are required when reinstalling the front seat assembly LH into the vehicle.
Be careful not to damage the front seat assembly LH, body exterior or interior parts.
Protect the front seat leg.
Protect the television display assembly.
| *A | w/ Front Seat Side Airbag | *B | for LH Side or w/ Rear Seat Entertainment System |
Connect each connector and attach the clamp under the front seat assembly LH to install the floor wire harness.
for LH Side or w/ Rear Seat Entertainment System:
1. Connect the 2 connectors.
w/ Front Seat Side Airbag:
1. Connect the front seat airbag assembly LH connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector.
w/ Front Seat Side Airbag:
1. Connect the cable to the negative (-) battery terminal.
for 1GR-FE:
Click hereGeneral>MAINTENANCE>1GR-FE BATTERY>INSTALLATION
for V35A-FTS:
Insert the 2 location pins of the front seat assembly LH through the 2 body holes and place the front seat assembly LH.
Temporarily install the front seat assembly LH with the 4 "TORX" screws.
Operate the slide and vertical power seat switch knob to slide the front seat assembly LH to the rearmost position.
Using a T50 "TORX" socket wrench, tighten the 2 "TORX" screws in the order shown in the illustration.
Operate the slide and vertical power seat switch knob to slide the front seat assembly LH to the frontmost position.
Using a T50 "TORX" socket wrench, tighten the 2 "TORX" screws in the order shown in the illustration.
71910F 6.INSTALL FRONT SEAT HEADREST ASSEMBLY LH
7. INITIALIZATION OF SEAT ECU (w/ Memory)
13. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART