| *A | w/ Rear Seat Entertainment System | - | - |
| *1 | FRONT SEAT HEADREST SUPPORT | *2 | FRONT SEATBACK PAD LH |
|
N*m (kgf*cm, in.*lbf) : Specified torque | ● | Non-reusable part |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 8 | RECLINING COVER PROTECTOR LH | 72554L | ( ) |
- | - |
| 9 | FRONT SEATBACK ASSEMBLY LH | - | - | - | - |
| 10 | WIRING HARNESS SUPPORT | 82712L | - | - | - |
| *A | w/o Rear Seat Entertainment System | *B | w/ Rear Seat Entertainment System |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 11 | FRONT SEAT INNER CUSHION SHIELD LH | 71862K | - | - | - |
| 12 | FRONT SEAT CUSHION SHIELD RH | 71811T | - | - | - |
| 13 | FRONT SEAT CUSHION SHIELD LH | 71812T | - | - | - |
| 14 | FRONT SEAT FRONT CUSHION SHIELD LH | 71867X | - | - | - |
| 15 | FRONT SEAT ASSEMBLY LH | - | - | - | - |
| *A | for Driver Side | *B | for Front Passenger Side |
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
87530E 1.INSTALL FRONT SEATBACK HEATER ASSEMBLY LH
| *a | Area A | *b | Area B |
| *c | Area C | *d | Bridge Part |
| *e | Positioning Standard | - | - |
The following procedure is performed to install the front seatback heater assembly LH to front seatback pad LH.
1. Remove the release paper of area A from the front seatback heater assembly LH and attach it to the front seatback pad LH aligning with the positioning standard.
2. Remove the release paper of area B from the front seatback heater assembly LH and attach it to the front seatback pad LH aligning with the positioning standard.
3. Remove the release paper of area C from the front seatback heater assembly LH and attach it to the front seatback pad LH aligning with the positioning standard.
4. Insert 4 bridge parts of the front seatback heater assembly LH into the groove of the front seatback pad LH.
Match the center marking guides of front seatback heater assembly LH with front seatback pad LH.
After removing the peeling paper, do not touch the surface of the tape with your fingers or cotton work gloves.
Do not reuse the front seatback heater assembly LH and front seatback pad LH.
Apply pressure to paste the front seatback heater assembly LH to the front seatback pad LH securely.
71705G 5.INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Rear Seat Entertainment System)
71776B 6.INSTALL FRONT NO. 1 SEATBACK BOARD COVER (w/ Rear Seat Entertainment System)
71777B 7.INSTALL FRONT NO. 2 SEATBACK BOARD COVER (w/ Rear Seat Entertainment System)
9.INSTALL FRONT SEATBACK ASSEMBLY LH
82712L 10.INSTALL WIRING HARNESS SUPPORT
71862K 11.INSTALL FRONT SEAT INNER CUSHION SHIELD LH
71811T 12.INSTALL FRONT SEAT CUSHION SHIELD RH (for Front Passenger Side)
71812T 13.INSTALL FRONT SEAT CUSHION SHIELD LH (for Driver Side)
71867X 14.INSTALL FRONT SEAT FRONT CUSHION SHIELD LH
15.INSTALL FRONT SEAT ASSEMBLY LH