| *A | w/ Child Restraint System Guide | - | - |
| *1 | NO. 1 SEATBACK PAD LH | *2 | HOG RING |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 11 | REAR NO. 1 SEAT ASSEMBLY LH | - | - | - | - |
| 12 | REAR NO. 1 SEAT ASSEMBLY RH | - | - | - | - |
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
87530 1.INSTALL REAR NO. 1 SEATBACK HEATER ASSEMBLY LH
| *a | A Area | *b | B Area |
| *c | C Area | *d | Bridge Area |
| *e | Matchmark | - | - |
Follow the steps below to install the rear No. 1 seatback heater assembly LH to the No. 1 seatback pad LH.
1. Remove the peeling paper on the A area and paste the A area of rear No. 1 seatback heater assembly LH to the No. 1 seatback pad LH as the matchmark.
2. Remove the peeling paper on the B area and paste the B area of rear No. 1 seatback heater assembly LH to the No. 1 seatback pad LH as the matchmark.
3. Remove the peeling paper on the C area and paste the C area of rear No. 1 seatback heater assembly LH to the No. 1 seatback pad LH as the matchmark.
4. Insert the bridge area to the groove of No. 1 seatback pad LH.
After removing the peeling paper, do not touch the surface of the tape with your fingers or cotton work gloves.
Do not reuse the rear No. 1 seatback heater assembly LH and No. 1 seatback pad LH.
Apply pressure to paste the rear No. 1 seatback heater assembly LH to the No. 1 seatback pad LH securely.
3.INSTALL SEPARATE TYPE REAR SEATBACK ASSEMBLY LH
71930Q 4.INSTALL REAR SEAT HEADREST SUPPORT ASSEMBLY
71702D 5.INSTALL REAR SEATBACK BOARD SUB-ASSEMBLY LH
72996H 6.INSTALL REAR SEATBACK COVER (w/ Child Restraint System Guide)
71834X 7.INSTALL REAR NO. 2 SEAT RECLINING COVER LH
72329G 9.INSTALL REAR NO. 2 SEAT ADJUSTER BOLT COVER
71833V 10.INSTALL NO. 1 SEAT NO. 2 RECLINING COVER RH
11.INSTALL REAR NO. 1 SEAT ASSEMBLY LH
12.INSTALL REAR NO. 1 SEAT ASSEMBLY RH