| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( ) |
- | - |
| 2 | CABLE FROM NEGATIVE BATTERY TERMINAL | - | - | - | - |
| 3 | NO. 1 RELAY BLOCK COVER | 82661 | - | - | - |
| 4 | SEMICONDUCTOR POWER INTEGRATION ECU | 82644 | ( ) |
- | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the semiconductor power integration ECU removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure below is for LHD vehicles.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
82661 3.REMOVE NO. 1 RELAY BLOCK COVER
|
Remove in this Direction | - | - |
82644 4.REMOVE SEMICONDUCTOR POWER INTEGRATION ECU
|
Remove in this Direction | - | - |
Detach the claw and pull up the semiconductor power integration ECU.
Disconnect the connector.
Using a thin-bladed screwdriver with its tip wrapped with protective tape, detach the claw, disconnect the lever connector and remove the semiconductor power integration ECU.