| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( ) |
- | - |
| 2 | FRONT SEAT ASSEMBLY LH | - | - | - | - |
| *A | for Driver Side | *B | for Front Passenger Side |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 11 | FRONT SEATBACK ASSEMBLY LH | - | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 12 | SEATBACK COVER WITH PAD | - | ( ) |
- | - |
| 13 | FRONT SEAT AIRBAG ASSEMBLY LH | 73920B | ( ) |
- | - |
| *1 | FRONT SEAT HEADREST SUPPORT ASSEMBLY LH | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat airbag assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
|
|
2.REMOVE FRONT SEAT ASSEMBLY LH
72495A 3.REMOVE FRONT SEAT VERTICAL ADJUSTER HANDLE LH (for Driver Side)
72526H 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
11.REMOVE FRONT SEATBACK ASSEMBLY LH
73920B 13.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH
|
|
Disengage the clamp.
Remove the 2 nuts and front seat airbag assembly LH.
Do not reuse the nut.
If the installation surface or surrounding area of the front seat airbag assembly LH is deformed or damaged, replace the front seatback frame sub-assembly LH, front seatback pad LH and front seatback cover sub-assembly LH.