| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | REAR SHOCK ABSORBER ASSEMBLY LH | 48540 | - | - | - |
| 2 | SUPPORT REAR AXLE HOUSING ASSEMBLY | 48530 | - | - | - |
| 3 | LOWER CONTROL ARM ASSEMBLY LH | 48730 | - | - | - |
| 4 | LOWER CONTROL ARM ASSEMBLY RH | 48720 | - | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear lower arm removal/installation are shown below.
Use the same procedure for the RH and LH side.
The following procedure is for the LH side.
48540 1.REMOVE REAR SHOCK ABSORBER ASSEMBLY LH
48530 2.REMOVE REAR SHOCK ABSORBER ASSEMBLY RH
48730 3.REMOVE LOWER CONTROL ARM ASSEMBLY LH
48720 4.REMOVE LOWER CONTROL ARM ASSEMBLY RH
Use the same procedure described for the LH side.