| *1 | TEMPERATURE SENSOR | *2 | TEMPERATURE SENSOR CLAMP |
| *3 | DRAIN PLUG | *4 | AUTOMATIC TRANSMISSION OIL PAN GASKET |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission wire removal/installation are shown below.
51440 1.REMOVE OIL PAN PROTECTOR ASSEMBLY
2.DRAIN AUTOMATIC TRANSMISSION FLUID
Remove the drain plug and gasket from the automatic transmission assembly and drain the ATF.
Install a new gasket and the drain plug to the automatic transmission assembly.
35106 3.REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
Remove the 10 bolts, automatic transmission oil pan sub-assembly and automatic transmission oil pan gasket from the automatic transmission case sub-assembly.
Some fluid will remain in the automatic transmission oil pan sub-assembly. Remove all of the bolts, and carefully remove the automatic transmission oil pan sub-assembly.
35394 4.REMOVE TRANSMISSION OIL CLEANER MAGNET
Remove the 4 transmission oil cleaner magnets from the automatic transmission oil pan sub-assembly.
Examine the particles in the automatic transmission oil pan sub-assembly.
Collect any steel chips with the removed transmission oil cleaner magnets. Carefully inspect the foreign matter and particles in the automatic transmission oil pan sub-assembly and on the transmission oil cleaner magnets to anticipate the type of wear you will find in the automatic transmission assembly.
Steel (magnetic): bearing, gear and clutch plate wear
Brass (non-magnetic): bush wear
82125J 5.REMOVE TRANSMISSION WIRE
| *1 | Temperature Sensor Clamp | *2 | Temperature Sensor |
|
Bolt |
|
Connector |
|
O-ring |
|
Pull Down the Lever |
Remove the 2 bolts and the 2 temperature sensor clamps, and disconnect the 2 temperature sensors.
Disconnect the 7 solenoid valve connectors and transmission wire from the transmission valve body assembly.
Disconnect the transmission wire connector.
Detach the claw, pull down the lever, and disconnect the transmission wire connector.
Remove the bolt and pull out the transmission wire from the automatic transmission case sub-assembly.
Remove the O-ring from the connector of transmission wire.
Remove the 2 O-rings from the 2 temperature sensors.