The main body ECU (multiplex network body ECU) controls the operation of the following lights:
No. 1 interior illumination light assembly (front footwell light LH)
No. 1 interior illumination light assembly (front footwell light RH)
No. 1 interior illumination light assembly LH (rear footwell light)*
No. 1 interior illumination light assembly RH (rear footwell light)*
*: w/ Rear Footwell Light
w/o Stop and Start System:
Inspect the fuses for circuits related to this system before performing the following procedure.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
The DOME CUT relay supplies power to the inside handle illumination lights. If all the lights that use power from the DOME CUT relay do not turn on, check the interior light auto cut circuit first.
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>Interior Light Auto Cut Circuit
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Front Footwell Lights | Operation of the following lights:
·
No. 1 interior illumination light assembly (front footwell light LH)
·
No. 1 interior illumination light assembly (front footwell light RH)
·
No. 1 interior illumination light assembly LH (rear footwell light)*
·
No. 1 interior illumination light assembly RH (rear footwell light)* |
OFF or ON | - |
*: w/ Rear Footwell Light
| Tester Display |
|---|
| Front Footwell Lights |
No. 1 Interior illumination light assembly (footwell light) turns on or off.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the power distribution box assembly.
for LHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
for RHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL
| *a | Component without harness connected (Power Distribution Box Assembly) |
- | - |
Remove the main body ECU (multiplex network body ECU) from the power distribution box assembly.
for LHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
for RHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5C-18 - MB-16 (FSPT) | Always | Below 1 Ω |
| 5F-22 - MB-16 (FSPT) | Always | Below 1 Ω |
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG (for LHD) | C |
| NG (for RHD) | D |
A
B
C
D