When the main body ECU (multiplex network body ECU) receives the light control switch position signal, it sends an illumination request signal to the headlight ECU sub-assembly and illuminates the clearance lights.
When the operation conditions of the daytime running lights are met, the main body ECU (multiplex network body ECU) sends an illumination request signal to the headlight ECU sub-assembly and illuminates the daytime running lights.
LH Side
RH Side
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Headlight ECU)>REGISTRATION
When replacing the headlight ECU sub-assembly LH, always replace it with a new one. If a headlight ECU sub-assembly LH which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Check the illumination of each clearance lights and daytime running lights.
| Result | Proceed to |
|---|---|
| LH side clearance light and daytime running light does not illuminate | A |
| RH side clearance light and daytime running light does not illuminate | B |
A
B
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Daytime Running Light | Daytime running light LH | ON | - |
| Clearance Light (+ Front Side Marker Light) | Clearance light LH | ON | - |
| Tester Display |
|---|
| Daytime Running Light |
| Tester Display |
|---|
| Clearance Light (+ Front Side Marker Light) |
Clearance lights and daytime running lights illuminate.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Interchange the headlight unit assembly LH with RH and connect the connectors.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>DISASSEMBLY
| Proceed to |
|---|
| NEXT |
NEXT
Check the operation of the clearance lights and daytime running lights of the headlight unit assembly LH.
Clearance lights and daytime running lights of the headlight unit assembly LH operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected (to Headlight ECU Sub-assembly LH) |
*b | Component without harness connected (to Headlight LED Unit Assembly LH) |
Remove the headlight unit assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>DISASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B-15 (LED3+) - G-8 | Always | Below 1 Ω |
| B-16 (LED3-) - G-7 | Always | Below 1 Ω |
| B-19 (BIN1+) - G-3 | Always | Below 1 Ω |
| B-5 (BIN-) - G-4 | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Daytime Running Light | Daytime running light RH | ON | - |
| Clearance Light (+ Front Side Marker Light) | Clearance light RH | ON | - |
| Tester Display |
|---|
| Daytime Running Light |
| Tester Display |
|---|
| Clearance Light (+ Front Side Marker Light) |
Clearance lights and daytime running lights illuminate.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Interchange the headlight unit assembly RH with LH and connect the connectors.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>DISASSEMBLY
| Proceed to |
|---|
| NEXT |
NEXT
Check the operation of the clearance lights and daytime running lights of the headlight unit assembly RH.
The clearance lights and daytime running lights of the headlight unit assembly RH operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected (to Headlight ECU Sub-assembly RH) |
*b | Component without harness connected (to Headlight LED Unit Assembly RH) |
Remove the headlight unit assembly RH.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>DISASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B-15 (LED3+) - G-8 | Always | Below 1 Ω |
| B-16 (LED3-) - G-7 | Always | Below 1 Ω |
| B-19 (BIN1+) - G-3 | Always | Below 1 Ω |
| B-5 (BIN-) - G-4 | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG