| *1 | REAR DISC BRAKE CYLINDER ASSEMBLY | - | - |
| ● | Non-reusable part | - | - |
If the rear disc brake cylinder assembly has been disassembled, perform air bleeding for the rear disc brake cylinder assembly.
Make sure not to scratch, damage or apply excessive force to any of the internal components of the rear disc brake cylinder.
To prevent rusting on the inside of the rear disc brake cylinder, perform the rear disc brake piston removal and installation quickly.
Do not clean the interior of the rear disc brake cylinder with brake cleaner.
Do not remove any parts unless specifically instructed to do so, and only remove the parts indicated.
1.REMOVE CYLINDER BOOT
Using a screwdriver with its tip wrapped with protective tape, remove the cylinder boot from the rear disc brake cylinder.
Do not damage the inner surface or cylinder boot groove of the rear disc brake cylinder.
47831 2.REMOVE REAR DISC BRAKE PISTON
Place a piece of cloth between the rear disc brake piston and rear disc brake cylinder.
Apply compressed air to remove the rear disc brake piston from the rear disc brake cylinder.
|
|
Do not allow any brake fluid to spatter.
3.REMOVE PISTON SEAL
| *a | Nut | - | - |
Using a screwdriver with its tip wrapped with protective tape, remove the piston seal from the rear disc brake cylinder.
Do not damage the inner surface or piston seal groove of the rear disc brake cylinder.
Do not allow the nut to rotate. If the nut is accidentally allowed to rotate, return it to its original position.
31478C 4.REMOVE REAR DISC BRAKE BLEEDER PLUG CAP
47547C 5.REMOVE REAR DISC BRAKE BLEEDER PLUG