Home › General › MAINTENANCE › REAR BRAKE FLEXIBLE HOSE
RM38G0E _V1 General _100461 MAINTENANCE _0468812 REAR BRAKE FLEXIBLE HOSE A

MAINTENANCE  REAR BRAKE FLEXIBLE HOSE  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
C457776N04
6.427,1.083 6.844,1.083 false 5.75,2.5 6.167,2.5 false 6.427,0.198 6.875,0.198 false 6.417,0.656 6.802,0.656 false 6.25,0.531 6.5,0.865 0.25,0.333 18 false 2 6.229,2.375 6.479,2.708 0.25,0.333 18 false 3 6.25,0.083 6.927,0.458 0.677,0.375 18 false 1 6.24,0.958 6.656,1.292 0.417,0.333 18 false 4

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISABLE BRAKE CONTROL - - - (Click here)
3 REAR WHEEL - - - -
4 DRAIN BRAKE FLUID - - (Click here) -

C456329N01
3,2.25 3,0.75 3,0.75 3.333,0.75 true 2.031,1.708 2.031,0.875 2.031,0.875 2.365,0.875 true 3,2.865 3,3.365 3,3.365 5.083,3.365 true 5,1.833 5,1.5 5,1.5 6.167,1.5 false 5.833,1.885 5.833,1.5 false 3.708,0.635 4.208,0.885 0.5,0.25 18 false 5 2.417,0.802 2.667,1.052 0.25,0.25 10 false ● 5.135,3.302 5.385,3.552 0.25,0.25 10 false *1 6.219,1.406 6.469,1.656 0.25,0.25 10 false ●

Procedure Part Name Code
Z101186

Z101188

Z101187

5 REAR FLEXIBLE HOSE 47319F (Click here) - -

*1 BRAKE TUBE - -
● Non-reusable part - -

C457474N01
2.083,0.833 2.25,0.417 2.25,0.417 2.75,0.417 true 2.198,1.083 2.531,0.417 false 5.083,3.5 5.333,3.083 5.333,3.083 5.75,3.083 true 5.083,3.781 5.5,3.083 true 3.333,1.083 4,1.083 false 3.469,1.25 3.719,1.25 3.719,1.25 3.719,1.083 false 5.125,4.417 5.458,4.417 false 4.417,5.083 4.75,5.083 false 2.917,3.25 2.917,2 2.917,2 4.667,2 true 2.865,3.625 2.865,5.292 2.865,5.292 3.198,5.292 true 5.802,3.021 6.135,3.271 0.333,0.25 10 false *1 2.802,0.354 3.135,0.604 0.333,0.25 10 false *1 4.052,0.979 4.385,1.229 0.333,0.25 10 false ● 5.51,4.323 5.844,4.573 0.333,0.25 10 false ● 4.802,4.979 5.135,5.229 0.333,0.25 10 false ● 5,1.875 5.25,2.292 0.25,0.417 18 false 6 3.552,5.146 3.802,5.563 0.25,0.417 18 false 7

Procedure Part Name Code
Z101186

Z101188

Z101187

6 REAR NO. 2 BRAKE TUBE FLEXIBLE HOSE 47324B (Click here) - -
7 REAR BRAKE TUBE FLEXIBLE HOSE 47321B (Click here) - -

*1 BRAKE TUBE - -
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear brake flexible hose removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

NOTICE:
·

While the battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

·

If both left and right rear flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position.



HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

Z101186

NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click here(Click here)



Hide 2.DISABLE BRAKE CONTROL

Z101186

Click here(Click here)

Hide 3.REMOVE REAR WHEEL

Hide 4.DRAIN BRAKE FLUID

Z101186

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.



Hide 47319F 5.REMOVE REAR FLEXIBLE HOSE

a.
C456330N01
0.271,0.052 0.771,0.552 0.5,0.5 18 false i 3.781,0.052 4.49,0.49 0.708,0.438 18 false ii, iii

i.

Remove the union bolt and gasket, and disconnect the rear flexible hose from the rear disc brake cylinder assembly.


ii.

Using a union nut wrench, disconnect the brake line while holding the rear flexible hose with a wrench.

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.




iii.

Remove the clip and rear flexible hose from the vehicle body.



Hide 47324B 6.REMOVE REAR NO. 2 BRAKE TUBE FLEXIBLE HOSE

a.
C457475N01
0.406,0.031 1.052,0.375 0.646,0.344 18 false i, ii

i.

Using a union nut wrench, disconnect the brake tube while holding the rear No. 2 brake tube flexible hose with a wrench.

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.




ii.

Remove the 2 clips and rear No. 2 brake tube flexible hose from the vehicle body.



Hide 47321B 7.REMOVE REAR BRAKE TUBE FLEXIBLE HOSE

a.
C457477N01
0.406,0.031 1.188,0.521 0.781,0.49 18 false i, ii

i.

Using a union nut wrench, disconnect the brake tube while holding the rear brake tube flexible hose with a wrench.

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.




ii.

Remove the 2 clips and rear brake tube flexible hose from the vehicle body.