Home › Engine / Hybrid System › STOP AND START › ENGINE STOP AND START ECU
RM38G0E _51 Engine / Hybrid System _101047 STOP AND START _0469045 ENGINE STOP AND START ECU A

STOP AND START  ENGINE STOP AND START ECU  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A489128N03
6.219,0.24 6.813,0.24 false 3.24,0.677 3.833,0.677 true 4.969,2.115 5.823,2.115 true 6.083,0.104 6.365,0.458 0.281,0.354 18 false 1 3.896,0.552 4.177,0.906 0.281,0.354 18 false 2 6.156,1.99 6.438,2.344 0.281,0.354 18 false 3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 READ NUMBER OF STARTER OPERATIONS - - - -
2 ECU INTEGRATION BOX RH 82877 - - -
3 ENGINE STOP AND START ECU 89261A (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the engine stop and start ECU removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)
Engine stop and start ECU Update ECU security key Vehicle control history (RoB) are stored (Click here)
·

Upload the number of starter operations

·

Reset air conditioning information

·

Learning air conditioning information

·

Clear the zero point calibration data

·

Deceleration sensor zero point calibration


Stop and start system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -




PROCEDURE

Hide 1. READ NUMBER OF STARTER OPERATIONS

Hide 82877 2.REMOVE ECU INTEGRATION BOX RH

Hide 89261A 3.REMOVE ENGINE STOP AND START ECU

a.
A486932N01
0.427,0.115 0.708,0.469 0.281,0.354 18 false i

i.

Using a thin-bladed screwdriver with its tip wrapped with protective tape, detach the 2 claws and remove the engine stop and start ECU.

NOTICE:
·

If the ECU integration box is deformed or damaged, replace it.

·

Do not bend the 2 claws more than necessary.