The No. 2 skid control ECU (brake actuator assembly) sends signals such as brake request signals to the ECM. If an abnormal signal is detected, the ECM stores DTC P163081.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| P163081 | Communication Error from VSC to ECM Invalid Serial Data Received | w/ Full-speed Range Following Function: When the dynamic radar cruise control system is operating, the ECM detects abnormal data sent from the No. 2 skid control ECU (brake actuator assembly) for 1 second or more. w/o Full-speed Range Following Function: When the vehicle speed is 30 km/h (20 mph) or more and the dynamic radar cruise control system is operating, the ECM detects abnormal data sent from the No. 2 skid control ECU (brake actuator assembly) for 1 second or more. |
·
Electronically controlled brake system
·
ECM |
Cruise Control | B |
Before replacing the ECM, refer to Service Bulletin.
Check for electronically controlled brake system DTCs.
| Result | Proceed to |
|---|---|
| Electronically controlled brake system DTCs are not output | A |
| Electronically controlled brake system DTCs are output | B |
A
B
Pre-procedure1
Clear the DTCs.
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC P163081 is not output | A |
| DTC P163081 is output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
for 1GR-FE: Click hereEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>ECM>REMOVAL
for V35A-FTS: Click hereEngine / Hybrid System>V35A-FTS (ENGINE CONTROL)>ECM>REMOVAL