Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › SFI SYSTEM
RM38G0E _51 Engine / Hybrid System _100527 1GR-FE ENGINE CONTROL _0469186 SFI SYSTEM C

1GR-FE ENGINE CONTROL  SFI SYSTEM  P055011  Power Steering Pressure Sensor/Switch Circuit Short to Ground  P055015  Power Steering Pressure Sensor/Switch Circuit Short to Battery or Open  


DESCRIPTION

The power steering oil pressure sensor is turned on when a power steering wheel load is generated by turning the steering wheel. The ECM regulates the engine idling speed according to the voltage output of the sensor.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note
P055011 Power Steering Pressure Sensor/Switch Circuit Short to Ground Power steering oil pressure sensor voltage is below 0.28 V for 0.5 seconds while the engine is running (1 trip detection logic).
·

Open or short in power steering oil pressure sensor circuit

·

Power steering oil pressure sensor

·

ECM


Comes on SAE: P0552
P055015 Power Steering Pressure Sensor/Switch Circuit Short to Battery or Open Power steering oil pressure sensor voltage is higher than 4.9 V for 0.5 seconds while the engine is running (1 trip detection logic).
·

Open or short in power steering oil pressure sensor circuit

·

Power steering oil pressure sensor

·

ECM


Comes on SAE: P0553

MONITOR DESCRIPTION

The ECM monitors the power steering oil pressure sensor voltage and uses this value to regulate the engine idling speed. When the power steering oil pressure sensor output voltage deviates from the normal operating range, the ECM determines that there is a malfunction in the power steering oil pressure sensor and stores a DTC.

WIRING DIAGRAM

A162851E24
5.042,0.573 5.354,0.74 0.313,0.167 10 false PSP 5.302,2.979 6.208,3.146 0.906,0.167 10 false C92 5.031,1.479 5.438,1.646 0.406,0.167 10 false VCAI 1.906,0.573 2.219,0.74 0.313,0.167 10 false PSP 1.99,1.479 2.219,1.646 0.229,0.167 10 false VC 5.042,2.396 5.5,2.552 0.458,0.156 10 false ETHW 5.302,3.135 5.667,3.313 0.365,0.177 10 false ECM 4.75,0.469 4.938,0.625 0.188,0.156 10 false 76 4.74,1.375 4.969,1.563 0.229,0.188 10 false 75 4.698,2.302 4.969,2.5 0.271,0.198 10 false 123 2.323,0.469 2.448,0.625 0.125,0.156 10 false 2 2.302,1.396 2.417,1.552 0.115,0.156 10 false 1 2.302,2.302 2.417,2.458 0.115,0.156 10 false 3 2,2.396 2.208,2.542 0.208,0.146 10 false E2 0.5,2.958 0.802,3.125 0.302,0.167 10 false C50 0.5,3.125 2.792,3.292 2.292,0.167 10 false Power Steering Oil Pressure Sensor

CAUTION / NOTICE / HINT

HINT:
·

If DTCs relating to different systems which share terminal E2 as their ground are stored simultaneously, there may be an open circuit between terminal E2 and ground.

·

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ECM - POWER STEERING OIL PRESSURE SENSOR)
a.

Disconnect the ECM connector.


b.

Disconnect the power steering oil pressure sensor connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(C50,C92)Location & Routing

Click Connector(C50)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>Power Steering Oil Pressure Sensor

Click Connector(C92)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>ECM

C50-2 (PSP) - C92-76 (PSP) Always Below 1 Ω
C50-1 (VC) - C92-75 (VCAI) Always Below 1 Ω
C50-3 (E2) - C92-123 (ETHW) Always Below 1 Ω
C50-2 (PSP) or C92-76 (PSP) - Body ground Always 10 kΩ or higher
C50-1 (VC) or C92-75 (VCAI) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.REPLACE POWER STEERING OIL PRESSURE SENSOR

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.REPLACE POWER STEERING OIL PRESSURE SENSOR
a.

Replace the power steering oil pressure sensor.

Click hereEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>POWER STEERING OIL PRESSURE SWITCH>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CONFIRM WHETHER DTC OUTPUT RECURS
3.CONFIRM WHETHER DTC OUTPUT RECURS
a.

Start the engine.


b.

Idle the engine for 5 seconds.


c.

Read the DTCs.

Powertrain > Engine > Trouble Codes
50001 372
Result:
Result Proceed to
P055011 and/or P055015 is output A
No DTC is output B




A

B

END