This DTC is stored when the sliding roof ECU (sliding roof drive gear assembly) has not been initialized.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B2343 | Position Initialization Incomplete | Sliding roof ECU (sliding roof drive gear assembly) has not been initialized | Sliding roof ECU (Sliding roof drive gear assembly) | Sliding Roof | A |
Refer to DTC B2341.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>B2341
If the sliding roof ECU (sliding roof drive gear assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear assembly) must be initialized.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>INITIALIZATION
When DTC B2342 and B2343 are output simultaneously, perform troubleshooting for DTC B2342 first.
Check that the sliding roof ECU (sliding roof drive gear assembly) can be initialized.
Sliding roof ECU (sliding roof drive gear assembly) can be initialized.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the sliding roof auto operation.
Auto operation operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Pre-procedure1
Clear the DTCs.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
B