The No. 1 skid control ECU (brake booster with master cylinder assembly) controls braking force according to the engine control system regenerative braking force and provides the hydraulic pressure necessary for operating the master cylinder and each wheel cylinder according to the servo pressure sensor.
Brake pressure control solenoid "E": Solenoid SSA
Brake pressure control solenoid "F": Solenoid SGH
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Note |
|---|---|---|---|---|---|
| C15057E | Brake Pressure Control solenoid "E" Actuator Stuck On | SSA valve malfunction (stuck closed, etc.). | Brake booster with master cylinder assembly | Brake Booster | Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) |
| C150B7E | Brake Pressure Control solenoid "F" Actuator Stuck On | SGH valve malfunction (stuck closed, etc.). | Brake booster with master cylinder assembly | Brake Booster | Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) |
After replacing the No. 1 skid control ECU (brake booster with master cylinder assembly), perform "Calibration".
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY
Check the DTCs that are output.
| Result | Proceed to |
|---|---|
| Only C15057E or C150B7E is output | A |
| C15057E or C150B7E and other DTCs are output | B |
A
for LHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for RHD)>REMOVAL
B