Use the following procedure to troubleshoot the parking assist monitor system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Ask the customer about the problems and the conditions at the time the malfunction occurred to make sure the problem symptom was not temporarily caused by radio waves in the surrounding environment.
The parking assist monitor display may be temporarily distorted due to radio waves around the vehicle.
| Problem Symptom | Cause |
|---|---|
| The problem symptom indicates a parking assist monitor display malfunction and the problem symptom cannot be reproduced. | The display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver. |
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
w/ Navigation System:
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
w/ Audio and Visual System (for Radio and Display Type, except 12.3 Inch Display):
w/ Audio and Visual System (for Radio and Display Type, for 12.3 Inch Display):
| Result | Proceed to |
|---|---|
| Navigation system and audio and visual system are normal | A |
| Navigation system is abnormal | B |
| Audio and visual system is abnormal | C |
A
B
C
w/ Audio and Visual System (for Radio and Display Type, except 12.3 Inch Display):
w/ Audio and Visual System (for Radio and Display Type, for 12.3 Inch Display):
Use the GTS to check if the CAN communication system is functioning normally.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output | A |
| CAN communication system DTCs are output | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check for DTCs and make a note of any codes that are output.
Clear the DTCs.
Try to reproduce the problem symptoms based on the recorded DTCs, and then check if the DTCs are output again.
C1622 is output from the radio receiver assembly*1 or radio and display receiver assembly*2. Therefore, if C1622 is output, proceed to the Problem Symptoms Table for the relevant systems.
w/ Navigation System:
*1: for 12.3 Inch Display
*2: except 12.3 Inch Display
w/ Audio and Visual System (for Radio and Display Type, except 12.3 Inch Display):
w/ Audio and Visual System (for Radio and Display Type, for 12.3 Inch Display):
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTCs are output | B |
A
B
Refer to Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
A
B
Diagnosis System
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DIAGNOSIS SYSTEM
Terminals of ECU
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>TERMINALS OF ECU
Data List / Active Test
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT