These DTCs are stored when a malfunction occurs in the No. 3 active noise control microphone system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B1AB396 | Middle Center Microphone Circuit Component Internal Failure | Engine running, engine speed is 1200 rpm or higher 3 seconds after the ignition switch is turned to ACC, the stereo component equalizer assembly detects a malfunction in the No. 3 active noise control microphone for 4 seconds or more continuously* |
·
Harness or connector
·
No. 3 active noise control microphone
·
Stereo component equalizer assembly |
Active Noise Control | A |
| B1AB41C | Middle Center Microphone Circuit Circuit Voltage Out of Range | When the stereo component equalizer assembly detects a No. 3 active noise control microphone connection malfunction for 4 seconds or more continuously 3 seconds after the ignition switch is turned to ACC* |
·
Harness or connector
·
No. 3 active noise control microphone
·
Stereo component equalizer assembly |
Active Noise Control | A |
*: Malfunction monitoring is not performed during the following conditions to prevent erroneous detection.
The battery voltage is less than 9.5 V.
Before 3 seconds have elapsed after the battery voltage has returned to normal.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Disconnect the S20 stereo component equalizer assembly connector.
Disconnect the d26 No. 3 active noise control microphone connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(S20,d26)Location & Routingewd_type=routing;type=c,c;code=S20,d26 Click Connector(S20)Body>No. 2 Floor Wire / Step Rear Floor Wire LH>Stereo Component Equalizer Assemblyewd_type=component;type=c;code=S20;pinno=5,19 Click Connector(d26)Body>No. 1 Roof Wire>Active Noise Control Microphone (Rear1 Center)ewd_type=component;type=c;code=d26;pinno=1,2 |
||
| S20-5 (MC3+) - d26-1 (MC3+) | Always | Below 1 Ω |
| S20-19 (MC3-) - d26-2 (MC3-) | Always | Below 1 Ω |
| S20-5 (MC3+) - Body ground | Always | 10 kΩ or higher |
| S20-19 (MC3-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Replace the No. 3 active noise control microphone with a new or known good one.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
A
B