Home › Engine / Hybrid System › V35A-FTS (FUEL) › FUEL SYSTEM
RM38G0E _51 Engine / Hybrid System _101368 V35A-FTS FUEL _0470020 FUEL SYSTEM G

V35A-FTS FUEL  FUEL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK

a.

Check the fuel pump operation.

NOTICE:

Do not start the engine.


Powertrain > Engine > Active Test
Tester Display
Control the Fuel Pump Duty Ratio (Brushless)
50004 372 39
i.

Check for pressure in the fuel tube sub-assembly from the fuel line. Check that sounds of fuel flowing from the fuel tank assembly can be heard. If no sounds can be heard, check the relay, fuel pump, ECM and wiring connectors.



b.

Inspect for fuel leaks.

i.

Check that there are no fuel leaks anywhere in the system after performing maintenance.

If there is a fuel leak, repair or replace parts as necessary.



Hide 2.CHECK FUEL PRESSURE

a.

Discharge the fuel system pressure.

Click hereEngine / Hybrid System>V35A-FTS (FUEL)>FUEL SYSTEM>PRECAUTION


b.
A487616

Disconnect the fuel tube sub-assembly.

Click hereEngine / Hybrid System>V35A-FTS (FUEL)>FUEL SYSTEM>PRECAUTION


c.
A407520C01
1.469,1.938 1.594,1.656 1.594,1.656 1.74,1.656 false 0.844,3.083 1.135,3.083 false 0.885,3.698 1.292,3.698 false 0.948,4.146 1.375,4.146 false 1.292,1.083 1.292,0.813 false 1.823,1.219 1.958,1.219 1.958,1.219 2.094,1.052 false 1.542,0.333 1.677,0.333 1.677,0.333 1.844,0.448 false 2.49,2.479 2.615,2.198 2.615,2.198 2.76,2.198 false 0.427,1.292 0.469,0.927 0.469,0.927 0.573,0.927 false 2.615,1.094 2.74,0.729 2.74,0.729 2.844,0.729 false 1.229,1.104 1.438,1.292 0.208,0.188 10 false *1 0.656,2.99 0.854,3.177 0.198,0.188 10 false *a 1.635,1.135 1.823,1.323 0.188,0.188 10 false *b 0.604,0.833 0.792,1.042 0.188,0.208 10 false *c 1.771,1.563 1.979,1.76 0.208,0.198 10 false *d 2.792,2.115 3,2.313 0.208,0.198 10 false *e 0.719,3.604 0.896,3.792 0.177,0.188 10 false *f 0.75,4.042 0.958,4.25 0.208,0.208 10 false *g 2.875,0.646 3.083,0.854 0.208,0.208 10 false *a 1.344,0.24 1.542,0.448 0.198,0.208 10 false *a
*1 Fuel Tube Sub-assembly (Vehicle Side)
*a SST (Hose Band)
*b SST (T-joint)
*c SST (Gauge)
*d SST (Hose Joint)
*e SST (Hose)
*f SST (Fuel Tube Connector)
*g Fuel Pipe (Vehicle Side)


Install SST (pressure gauge) as shown in the illustration.

SST
09268-45101  (09268-41250, 09268-41260, 09268-41280, 09268-41500, 09268-41700, 95336-08070)


d.

Wipe up any spilled fuel.


e.

Connect the cable to the negative (-) battery terminal.


f.

Operate the fuel pump.

NOTICE:

Do not start the engine.


Powertrain > Engine > Active Test
Tester Display
Activate the Circuit Relay (Brushless)
50004 372 40

g.

Measure the fuel pressure.

Standard Fuel Pressure:

196 to 833 kPa (2.0 to 8.5 kgf/cm2, 28 to 121 psi)


·

If the fuel pressure is less than the standard, check the fuel hoses and their connections, fuel pump, fuel filter assembly and fuel main valve assembly.

·

If the result is not as specified, replace the fuel main valve assembly.



h.

Start the engine.


i.

Measure the fuel pressure at idle.

Standard Fuel Pressure:

196 to 833 kPa (2.0 to 8.5 kgf/cm2, 28 to 121 psi)


HINT:

Refer to Standard Idle Speed.

Click hereEngine / Hybrid System>V35A-FTS (ENGINE MECHANICAL)>ENGINE>ON-VEHICLE INSPECTION



j.

Stop the engine.


k.

Check that the fuel pressure remains as specified for 5 minutes.

Standard Fuel Pressure:

98 kPa (1.0 kgf/cm2, 14 psi) or more


If the result is not as specified, check the fuel pump, fuel main valve assembly and/or fuel injector assemblies.


l.

After checking the fuel pressure, disconnect the cable from the negative (-) battery terminal and carefully remove SST to prevent fuel from spraying.


m.

Connect the fuel tube sub-assembly.

Click hereEngine / Hybrid System>V35A-FTS (FUEL)>FUEL SYSTEM>PRECAUTION


n.

Connect the cable to the negative (-) battery terminal.


o.

Inspect for fuel leaks.


Hide 3.CHECK FUEL PRESSURE (for High Pressure)

a.

Start and warm up the engine.


b.

Check the high pressure side fuel pressure at 3000 rpm (shift lever in N, engine warmed up and A/C off).

Powertrain > Engine > Active Test
Active Test Display
Control the Injection Mode
Data List Display
Fuel Pressure (High)
50004 372 42004 265
Standard Fuel Pressure:

2800 to 20000 kPa (28.6 to 203.9 kgf/cm2, 406 to 2900 psi)


If the result is not as specified, check the fuel pump, fuel (engine room side) pump assembly, fuel pressure sensor and wire harnesses.


c.

Stop the engine.