The light control LED ECU internally boost the power supply voltage to ensure a constant supplied current for the low beam LED of their respective headlight.
By monitoring the LED power supply voltage, abnormal current and malfunctions can be detected.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B243900 | Headlight LH Circuit |
Detection condition:
All of the following conditions are met:
-
Ignition switch ON
-
Low beam headlights on
Malfunction status:
·
Headlight LED unit assembly LH malfunction
·
Open/short in Lo/Hi beam circuit
Malfunction duration:
10 seconds or more |
·
CXPI communication system
·
Headlight housing LH |
Main Body | B |
| B243A00 | Headlight RH Circuit |
Detection condition:
All of the following conditions are met:
-
Ignition switch ON
-
Low beam headlights on
Malfunction status:
·
Headlight LED unit assembly RH malfunction
·
Open/short in Lo/Hi beam circuit
Malfunction duration:
10 seconds or more |
·
CXPI communication system
·
Headlight housing RH |
Main Body | B |
Pre-procedure1
None
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| B235887 and B235987 is not output | A |
| B235887 or B235987 is output | B |
Post-procedure1
None
A
B
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
Turn ignition switch to ON.
Operate the light control switch to turn on the low beam headlights and wait 10 seconds or more.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| B243900 is not output | A |
| B243900 is output | B |
Post-procedure1
None
A
B
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
Turn ignition switch to ON.
Operate the light control switch to turn on the low beam headlights and wait 10 seconds or more.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| B243A00 is not output | A |
| B243A00 is output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B