The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
17400M 3.REMOVE CONVERTER WITH CATALYST ASSEMBLY RH
17735 4.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
12601F 5.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
82121 6.DISCONNECT ENGINE WIRE
28192 7.REMOVE STARTER COVER
28100 8.REMOVE STARTER ASSEMBLY
28181 9.REMOVE STARTER TERMINAL